Are there any problems with my 2004 Columbia?

Are there any problems with my 2004 Columbia?

Not open for further replies. I have a 2004 Columbia with a 60 series Detroit and for the last two years there has been an intermitent electrical problem. The tach and speedometer will go to zero while the warning beeper is screaming, the shift indicator will go blank, sometimes the truck and traliler ABS indicator sounds as well.

Are there any problems with the Freightliner Columbia?

Discussion in ‘ Freightliner Forum ‘ started by raclown, Feb 1, 2009 . Not open for further replies. I have a 2004 Columbia with a 60 series Detroit and for the last two years there has been an intermitent electrical problem.

What are the fault codes for Detroit Diesel engines?

DETROIT DIESEL Engine Fault Codes list DTC Code Description DDEC V Circuit 11 P 187 4 Chain PTO. Short circuit in the power 11 P 187 7 control system PTO wrong answers 12 P 187 3 Chain PTO. Short circuit in the ground 13 P 111 4-level circuit antifreeze. Short circuit in the ground 13 P 111 6 second-level circuit antifreeze.

How to troubleshoot Flash code 61 Detroit Diesel?

The following procedure will troubleshoot Flash Code 61.‪ Perform the following steps to test alternator ground.‪ Disable the alternator by removing the alternator belt. Start and run the engine; warm to greater than 87°F (30°C). Does the code return?

Is the Freightliner Columbia 2006 having AC problems?

Freightliner Columbia 2006 is having AC problems. Have truck repair questions? Ask an Expert By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them. Freightliner Columbia 2006 is having AC problems. I have A/C problems in…

Why is the a / C clutch on my Columbia not working?

You should see a light on your test light and the a/c clutch should engage. If so, the high pressure switch is bad. If not, you have a bad pin in the plug, a break in the wire between the switches, or bad pin going into the low pressure switch. Diagrams and troubleshoot sheet below.

Where does the power go on a Freightliner Columbia?

Head unit (controls in cab at dash or main switch) to plug at firewall. Then power goes to high pressure switch. The power then goes to low pressure switch. Then power goes to A/C clutch.

What are the symptoms of a bad camshaft position sensor?

The engine may stall intermittently. You may notice poor engine performance including irregular acceleration, misfiring, hard starting, or surging. On some car models, a failed CMP sensor will prevent the ignition from making a spark, so that the engine won’t start at all.

Can a faulty crankshaft sensor cause a car to stop?

The crankshaft sensor is necessary for your car engine to run on most car models. You also have a camshaft position sensor on some car models, which the car uses if the camshaft sensor is faulty. Here, a faulty crankshaft position sensor may not cause the car to stop entirely.

When do proximity sensors beep on a car?

FYI they only beep for me when you are within a very short distance say 12 inches of the obstruction. They solid beep when you are at the minimum distance. This goes for front and rear sensors. I believe parktronic is standard on UK/ European cars. Click to expand…

https://www.youtube.com/watch?v=-s6_5PVRWYU

Why is the AC not working on my Freightliner Columbia?

If you have power to high pressure, then the connection between the high pressure switch and low pressure switch is the fault. Power goes this way. Head unit (controls in cab at dash or main switch) to plug at firewall. Then power goes to high pressure switch. The power then goes to low pressure switch. Then power goes to A/C clutch.

How many horsepower does a Columbia 400 have?

The year 2006 was marked by lots of good and a little bad news at Columbia. Sales of the company’s two models, the 310-horsepower normally aspirated 350 and the turbocharged and intercooled 400, reached new levels.

Why does my car shut off after I stop driving?

If you car shuts off after you stop it is because the engine is very sensetive at the idle. This can be caused by a lot of things but is usually caused by a lean fuel mixture, causing the idle to drop too low. A faulty throttle body can also cause this.

Are there any problems with the series 60 Detroit engine?

Coolant Leakage Older Detroit engines are prone to coolant leakage in the EGR (exhaust gas recirculation) system. Though the problem is not necessarily severe, it can lead to white tail pipe smoke, mild overheating and coolant loss over time. The Series 60 was one of the first in the industry to be offered with a drive-by-wire system.

How is the ECU dependent on the drivetrain?

The engine and drivetrain are the most dependent on the ECU. Through a numerous array of electronic sensors, chips, and components within the vehicle, the ECU can transmit data feedback to the engine. The nature of this feedback will determine which function the engine will perform next.

What happens when the ECU of a car goes bad?

Car batteries have electronic cells which need to function in order for the ECU to function. If any of the cells in your car battery are dead, then your ECU is going to fail soon afterward. Once all the cells are dead, your entire vehicle won’t be able to function either. You won’t be able to even start your vehicle and get the engine running.

Can a check engine light get clogged up?

The EGR valve can get clogged up or fail entirely. If you’re even slightly mechanically inclined, you can remove the valve, clean it up, and reinstall it in a relatively short amount of time. If the valve needs to be replaced, expect to pay at least $125 for a brand-new, OEM-quality unit.

What causes a Freightliner Columbia engine to quit?

You many have a fault with one of these or wiring with the datalink. If the engine is quitting that tells me a loss of ignition power or unswitched battery power. The main power to the cab could be lose or corroded at the firewall or where ever it enters.

When does the Check Engine light turn on?

The orange, engine-shaped icon on your car dashboard’s instrument cluster is programmed to turn on when the vehicle’s electronic brain detects something is wrong.

How many volts are in the Columbia ECM?

Click to expand… Series 60 12.7 year 2003 i checked harness pins for volts and the big pin close to cab has 4 pins with 12 volts and a 5 large pin cable above it has two pins with 12 volts.

What’s the problem with the ECM on a Freightliner Columbia?

So ecm is getting power but dash is not reading anything from it shows 0 volts no eng with alot of faults and also check eng and protect is constantly on once you turn the key. Also dash shows option with EC with lines across seems like there is nothing coming out of ecm.

Are there any problems with Freightliner Columbia elecrical engines?

If the engine ECM has experience a loss of unswitched battery power or communitcation failures from the 1939 datalink it will log codes for that which should be able to point you in the right direction for a solution. Overall a great company to work for. They genuinely care about the drivers and are constantly looking for ways to improve.

Are there any electrical problems in your RV?

Electrical problems in an RV or camper are very common, and often RV owners don’t know where to start when they deal with them. This article provides some basic information for the RV owner to help diagnose and repair electrical problems efficiently and safely. I’d like you to:

What should I hear when my AC unit fails on a Freightliner?

Freightliners use a simple dial on the HVAC control unit to control the setting of the AC system. On a freightliner, the sound of the compressor starting is unmistakable. You should hear a low “hum” followed immediately by the cooling fan turning on. If you do not hear the compressor, it may have failed or is leaking.

How big is the Detroit Diesel Series 60?

The Detroit Diesel Series 60 is an inline-six 4 stroke diesel engine produced since 1987. At that time, it differed from most on-highway engines by using an overhead camshaft and ” drive by wire ” electronic control. In 1993, it was popular on many USA buses in the 11.1 L (677 cu in) displacement.

What kind of truck is the 2004 Freightliner Columbia?

2004 FREIGHTLINER FLD120SD, REAR MIXER, Jun. 30, 2021 – Housby Online Sales – STARTED ON SITE – NOT ROAD TESTED. DID NOT GET MIXER SYSTEM TO OPERATE -…

When did Detroit Diesel change to dual ECM?

In 2007 – 2010 (2008 -2011 trucks), the Detroit Diesel 14L engine was modified to meet new emissions standards and went to a dual ECM configuration (DDEC VI). This engine ran higher compression, higher injector pressure and a DPF exhaust filter.

Are there any problems with the Detroit Series 60?

This issue did not affect all pre-2002 Series 60 engines, but it was a problem that occurred and could cause catastrophic engine failure. As with most engines, it’s a good idea to keep an eye on your cooling system. Overheating is the cause of many major issues with diesel engines, so maintaining this system can help with many preventable issues.

Where did 60 Minutes report on Baia city?

Seth Doane dives into waters off the coast of Italy to report on Baia, a city that sunk into the sea between the 4th and 5th centuries. Watch the story on 60 Minutes Plus, streaming now, only on Paramount+.

Why does my GMC air conditioner stop working?

For about 5 miles the A/C worked normally till we hit a R/R and the bump made it stop blowing cold air and he was finally convinced. Back to the shop and 30 min later they found the problem. Turned out to be the low pressure switch, (under hood on bottom of small tank) it was corroded and causing a loss of electrical contact.

How can I tell if my AC is low or high?

To gauge the pressure, hook up a gauge set to the AC system and record the pressures of both low and high sides. Check the ambient temperature and see if the pressures match the numbers on the pressure chart. Compare the pressure readings with the pressure chart.

What should the pressure be on the low side of the AC?

The pressure reading from the low side should be between 25 and 30 psi and the high side between 200 and 250 psi. But if you see the AC low side high, high side low, such as the low side is 100 and the high side is 150, there might be problems with any of the inner components.