Why is my C320 no crank and electric issues?
P2037 no or incorrect CAN message from control unit N15/3 ETC (EGS) communication fault. I was advised to check maxi fuses and front SAM fuses 52 53 54 and starter relay. All is fine and also i replaced all maxi fused. Only 60a yellow (position f6) looked overburned.
What does no start no crank no click mean?
If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that. In the old days, power flowed through the ignition switch and down to the starter solenoid. Not anymore.
Why does my Mercedes not start when I charge the battery?
This Mercedes-Benz is not starting because of a low battery. In this case, what you need to do is trickle charge your battery using any of these 12 volt battery trickle chargers. If you need help read this article on How to charge a Mercedes-Benz the right way. Mercedes won’t start, and it’s not the battery.
Why is my Mercedes Benz starter not working?
Often times, when the starter is defective or seizes up it will blow out the fuse that protect the starter circuit. Another thing that you can try is to hit the starter with a rubber hammer a couple of times. Depending what kind of starter problems you have, the starter may work a few more times.
Why does my car say no crank no start?
You’d be surprised at how a dirty battery connection can affect electrical system performance. The corrosion buildup between the battery terminal and the battery cable can cause a no-start condition the same way a loose battery connection can. This is a simple, and often overlooked, cause of no crank/no start problems.
This Mercedes-Benz is not starting because of a low battery. In this case, what you need to do is trickle charge your battery using any of these 12 volt battery trickle chargers. If you need help read this article on How to charge a Mercedes-Benz the right way. Mercedes won’t start, and it’s not the battery.
Often times, when the starter is defective or seizes up it will blow out the fuse that protect the starter circuit. Another thing that you can try is to hit the starter with a rubber hammer a couple of times. Depending what kind of starter problems you have, the starter may work a few more times.
How many fuses do you need to start a GM car?
But then you must have two good fuses in the starting circuit, two good relays, several good fuses to the BCM, good fuses to the PCM, and good grounds all around. Click on the image here to pull up a PDF of a typical GM starting system wiring diagram.
What happens when a Mercedes Benz fuse blows?
If a fuse has blown, the inside element will be melted. Blown fuses must be replaced with fuses of the same rating, which you can recognize by the color and value. If a newly inserted fuse also blows, have the cause traced and rectified at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.
What should I do if my Mercedes Benz won’t start?
Start the car and you should be able to get around 60 psi. When the engine is running and when you turn off the engine the pressure should stay steady. Always perform this test on a cold engine. Next, make sure that the fuel injector connections are secure and not loose. Check the fuel pump and the fuel pump relay.
Why is the battery on my Mercedes Benz not working?
Hint: Starter Problem or Low Battery This may seem obvious, but an old battery is the root of many headaches and can cause all sorts of malfunctions on Mercedes-Benz cars. How old is the battery on your Mercedes-Benz?
What are common reasons my Mercedes-Benz C230 won’t start?
What are common reasons my Mercedes-Benz C230 won’t start? While there are a variety of reasons your Mercedes-Benz C230 won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter. How is a no-start diagnosis fixed?
What to know about your Mercedes-Benz C230?
See what others are asking about their Mercedes-Benz C230. Get answers from RepairPal’s community of auto experts and enthusiasts. I had a hose replaced that busted. had to tow car because still wouldn’t start. there are no check engine light that…
Where is the starter fuse on a Mercedes Benz?
The starter fuse is, F59 15A/20A Starter Relay, in the under hood drivers side fuse panel. It is a 15 amp or a 20 amp fuse. Check that fuse first if is blown and you need to desperately move the car try putting in a 25 amp fuse which should let the car start.
What should the fuse be on a Mercedes W211?
It is a 15 amp or a 20 amp fuse. Check that fuse first if is blown and you need to desperately move the car try putting in a 25 amp fuse which should let the car start. At that point there is a very good chance that the starter needs to be replaced if fuse 59 was blown. I recommend changing the fuse back to a 15 amp after the repair. Loading…
What are the signs of a bad starter relay?
Broken or corroded wiring – Damaged or dirty wires to the battery or to the starter solenoid (or wires that are loose) can prevent sufficient power from reaching the starter. Alternator – The alternator is designed to power all of your car’s electrical systems when the vehicle is running. It also recharges the battery.
Why did my Mercedes-Benz C320 2001 break down?
My c320 2001 with 97k broke down. On Saturday i jumped in to the car as usual started the engine and brake faults appeared. I was suprised and switched engine off for restart having hope it will disappear.
P2037 no or incorrect CAN message from control unit N15/3 ETC (EGS) communication fault. I was advised to check maxi fuses and front SAM fuses 52 53 54 and starter relay. All is fine and also i replaced all maxi fused. Only 60a yellow (position f6) looked overburned.
If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that. In the old days, power flowed through the ignition switch and down to the starter solenoid. Not anymore.
My c320 2001 with 97k broke down. On Saturday i jumped in to the car as usual started the engine and brake faults appeared. I was suprised and switched engine off for restart having hope it will disappear.
What are the symptoms of a bad ECM power relay?
A bad relay may cause the vehicle to crank, but not start, or sometimes not even crank at all. 3. Battery drain or dead battery. A failed ECM power relay can also cause a battery drain or dead battery. If the relay shorts it can leave power on to the computer, even when the vehicle is turned off.
Can you erase a fault code on a Mercedes Benz?
Can clear fault codes. Can read and erase all fault codes on Mercedes-Benz cars. Only works on MB but can perform further troubleshooting including SBC brake systems, convertible systems, Air Conditioner (A/C) system. 3. Mercedes-Benz Star Diagnostic DAS This is diagnostic scanner used at Mercedes-Benz dealerships.
What kind of car engine does not crank?
However, when i turn the key all the way, the engine does not even try to crank. It almost feels as if only the starter is disconnected or something from the car entirely. (I know nothing about car engines) I drive a 2004 C230 sedan.
Can clear fault codes. Can read and erase all fault codes on Mercedes-Benz cars. Only works on MB but can perform further troubleshooting including SBC brake systems, convertible systems, Air Conditioner (A/C) system. 3. Mercedes-Benz Star Diagnostic DAS This is diagnostic scanner used at Mercedes-Benz dealerships.