Why is my 3406E cat engine not cranking?
If you haven’t changed that sensor already. Have you checked the lift pump PSI at main filter base it should read 40 psi just cranking, 75 psi running. It will probably be either lack of fuel or lack of electrics. As truck shop noted, the hand primer should be hard to push. If these engines do get airlocked they take a lot of cranking to bleed.
Why does my C15 Cat truck not start?
Check valve would be the likely cause for the “won’t start after a day or so” but shouldn’t account for the “starts, runs for a minute or so then quits” and does this twice back to back. All the valves do is hold pressure/ prime when it’s not running.
Why does my car not start when I crank the engine?
If the engine doesn’t crank, or makes an unusual noise when cranking, you may have a starting system problem. The car’s security system may have made an error that disabled the fuel or ignition system, or the chip in the key may have failed.
How to troubleshoot a C13 or C15 engine?
B. Use the appropriate engine turning tool to put either the No. 1 piston or the No. 6 piston at the top center. Refer to the Systems Operation/Testing and Adjusting. C. Refer to Table 4. After the top center position has been located, rotate the crankshaft for the number of degrees that is applicable to your engine model.
Where are the permanent batteries on a 3406E cat?
One goes to the engine sensors and injectors, the other one joins the chassis wiring. On the chassis plug you should have; Permanent battery positive to pins 48, 52, 53. Permanent battery ground to pins 63, 65, 67. Ignition switched battery positive to pin 70. I forgot to mention we have changed the transfer pump too. Thanks. Ok.
What kind of cam lobe does 3406E injector use?
The 3406E injector relies on a cam lobe for the injection pressure (MEUI). You are referring to the HEUI system which doesn’t apply in this case.
Where are the battery plugs on a 3406E cat?
On the ECM there are two plugs. One goes to the engine sensors and injectors, the other one joins the chassis wiring. On the chassis plug you should have; Permanent battery positive to pins 48, 52, 53. Permanent battery ground to pins 63, 65, 67. Ignition switched battery positive to pin 70.
Is the Caterpillar 3406E a bulletproof diesel engine?
The Caterpillar 3406E is a fairly bulletproof diesel engine in terms of problems. However, as with all engines, there are usually a few issues that are well known. You may have heard of oil leaks with the 3406E. A common spot for leaks is near the rear side of the engine around the spacer plate and the cylinder block.
Why does my Kenworth W900L cat not start?
1999 kenworth W900l has a 3406E Cat 475 hp was idleing and died. Now will not start. Has code 46. We have power to ecm and have replaced several sensors. It will run on ether but that’s it. Changed fuel filter and some fuel lines. Still will not start. Any suggestions will be appreciated.