Where is the starter clutch on a virago?
The starter clutch located inside the left side cover is the worn part. It is designed to protect the engine from backfiring, when starting. This part eventually wears out and is relatively easy to replace. However, if you are not mechanically inclined, do not attempt this repair.
What’s the starter number on a Yamaha Virago 750?
Adding three shims, part number 156-11563-00, in the starter nose will take up any wear caused by prolonged use while this symptom existed. The XV-700’s and 750’s require a different repair because they do not have the starter clutch. Yamaha suggests changing the large tension clip, P/N 904-68291-06-00, on the idler gear.
Where is the compression spring on a Yamaha Virago?
Replace the idler gear compression spring, P/N 905-01156-36-00, and starter gear tension clip, P/N 904-68291-14-00. These parts are located inside the left side cover. Yamaha does not recommend welding the starter ring gear because if the engine should backfire you could do serious damage to the case.
Why does my Virago starter make a clicking noise?
A low battery can create all kinds of starting problems such as: The starter makes a rapid clicking noise when you push the starter button. (Low voltage will cause the starter relay not to engage the starter gear into the flywheel.) The starter clutch located inside the left side cover is the worn part.
The starter clutch located inside the left side cover is the worn part. It is designed to protect the engine from backfiring, when starting. This part eventually wears out and is relatively easy to replace. However, if you are not mechanically inclined, do not attempt this repair.
What are the symptoms of a faulty Yamaha Virago starter?
Symptoms of a faulty electrical starter on the Yamaha Virago motorcycle include: Typically, the engine should come to life immediately on pressing the starter. However, if the starter turns slowly and the bike cannot start promptly, something is wrong with the starter. II. Starter Makes a Clicking Noise:
How do you start a Yamaha Virago bike?
To start your Virago you: turn the choke on (cold starting only), make sure the bike is in neutral, turn the key to the on position, turn the kill switch to the on position, using one finger push the starter button. If your engine is tuned properly, it will start in less than three revolutions.
A low battery can create all kinds of starting problems such as: The starter makes a rapid clicking noise when you push the starter button. (Low voltage will cause the starter relay not to engage the starter gear into the flywheel.) The starter clutch located inside the left side cover is the worn part.