Where is the ECM located on a 2008 Nissan Altima?
The ECU is located behind the glove box. Your going to have to drop the glove box and you will see it to the right of the blower motor. There are 6 or 7 screws that hold the glove box in place and then you have to pull on it a little bit to release the clips.
What are the best parts for a Nissan Altima?
Maintain the intelligent performance of your 2008 Nissan Altima with Genuine Nissan Accessories. Shop Value Advantage® Parts: Value Advantage® parts offer Nissan-validated fit and performance at affordable prices.
What to do with a 2008 Nissan Altima?
Repairing or updating your 2008 Nissan Altima with OEM parts ensures that same excitement for the full life of your Nissan. Upgrade your 2008 Nissan Altima with innovative technology additions. Explore more with the right accessories for your 2008 Nissan Altima.
Why did my Altima 2.5L not start up?
My 2013 altima 2.5L could not start an engine. It turned on P0101 and P2119. After replacing an air filter and cleaning MAF and throttle body, it seemed that everything is fine. However, in the next day, ECM set P0101 again. I replaced MAF filter and PCV valve, but it could not solve my problem.
When does the ECM set p0101 on a Nissan?
I found that ECM set P0101 only when my car starts an engine. ECM has never set confirmed or pending P0101 during driving. There was no exception for more than 10 samples. So, I conclude that there is no drivability issue and my car may need to reprogram the ECU according to TSB from nissan.
Maintain the intelligent performance of your 2008 Nissan Altima with Genuine Nissan Accessories. Shop Value Advantage® Parts: Value Advantage® parts offer Nissan-validated fit and performance at affordable prices.
Repairing or updating your 2008 Nissan Altima with OEM parts ensures that same excitement for the full life of your Nissan. Upgrade your 2008 Nissan Altima with innovative technology additions. Explore more with the right accessories for your 2008 Nissan Altima.
My 2013 altima 2.5L could not start an engine. It turned on P0101 and P2119. After replacing an air filter and cleaning MAF and throttle body, it seemed that everything is fine. However, in the next day, ECM set P0101 again. I replaced MAF filter and PCV valve, but it could not solve my problem.
I found that ECM set P0101 only when my car starts an engine. ECM has never set confirmed or pending P0101 during driving. There was no exception for more than 10 samples. So, I conclude that there is no drivability issue and my car may need to reprogram the ECU according to TSB from nissan.