Where is the CDI inlet port in a Mercedes?
Its basically in the very centre of the engine bay in between each bank directly under the fuel filter. Various components have to be removed to access it, charge pipes, turbo, fuel filter and housing, ect. A bit in depth to describe on a thread. The trickiest bit is attaching the linkages to the motor.
Where can I find Mercedes Benz ML320 parts?
No matter what type of ML320 parts you may need for your vehicle, we can help you to locate it at eEuroparts.com so that you can get your Mercedes Benz in top working condition once again. Only ground shipping available on this item. In order to add an item to a project you must be logged in.
What kind of stability control does the Mercedes ML320 have?
The M-Class of vehicles, including the ML320, was the first luxury sports utility vehicle to include stability control that was capable of detecting a loss of control and then instantly intervene in order to return the vehicle back to the original course. This class also offered side-impact and front-impact airbags.
When did the Ford ML320 come on the market?
This class also offered side-impact and front-impact airbags. When it first hit the market in 1998, the ML320 was voted as the North American Truck of the Year at the North American International Auto Show. The ML320 was eventually replaced by the ML350.
Why is my CDI inlet shut off motor not working?
The fault was the car going into limp home mode. Various fault codes were present but many due to the under bonnet fuse number 54 (15 amp) having been blown by the inlet port shut off motor. A known problem is the air intake duct is sealed to the turbo Intake spigot by a rubber seal.
Where is the intake port shutoff motor located?
The motor must be located in a different spot because mine in on the top of the engine.It looks like the turbo charger has to be removed to get at it. Last week my 07 Blutec (90,000 km/55,000 miles) went into limp mode.
How to replace the shut off motor on a Mercedes?
1 screw, 1 bolt, image (h). At the bracket to the front of the turbo remove the bolt into the turbo, the bolt down into the shut off motor, and the 2 bolts into the head. Remove bracket, 4 bolts total, image (j). 2 bolts, image (b). The turbo should allow enough play to remove the intercooler pipe.
Do you need an inlet port shut off motor?
Got an 09 E320 Bluetec in today that needs a new inlet port shut off motor. Any pointers or suggestions on the job that anyone can offer will be much appreciated. Looks pretty straight forward from what I’ve read so far.
Its basically in the very centre of the engine bay in between each bank directly under the fuel filter. Various components have to be removed to access it, charge pipes, turbo, fuel filter and housing, ect. A bit in depth to describe on a thread. The trickiest bit is attaching the linkages to the motor.
How to replace inlet port shutoff motor on OM642?
Be gentle with plastic intake arm that attaches to port shutoff motor, gently pry plastic clip out and new one in , if you break the arm your going to need a new intake manifold , left or right.use plenty of lube on turbo bolts as necc, only use hand tools,clean working area real good, and dont drop any thing Any secret to priming these things.
How much does it cost to replace a CDI port on a Mercedes?
Mercedes wanted about £700 inc. labour to replace. We kicked up a fuss as the car has an FSH and was under warranty ended up paying about £200. Wasn’t a good experience and almost sold the car but touch wood no issues for a while.