Where can I get a new Volvo radiator?
I replaced the radiator with a new one from Volvo (OEM Volvo made by Valeo). Along the way I took photos and wrote the whole procedure up step-by-step. It was a big job and I took lots of photos so it was easier to put it into a PDF file (attached below) rather than try to upload the images one by one to the website.
What kind of radiator does a 97 GLT have?
The radiator on my ’97 855 GLT developed a crack in the plastic endcap near the upper radiator inlet. I replaced the radiator with a new one from Volvo (OEM Volvo made by Valeo).
How to change coolant on 2012 Volvo XC70?
MVS user headrc recently asked the MVS forum how to open the draincock on his 2012 Volvo XC70 so he could flush the radiator. A lively discussion broke out on coolant replacement (Isn’t that just always the case?)
Why is my Volvo radiator blowing coolant out?
These pre-2001 FWD and AWD Volvos — P80 family — share common components, and procedures are often similar or identical. Nine out of ten P80 radiators fail at the plastic endcaps, and may blow coolant out the crack in a gentle rush or whistle.
How to remove and replace a radiator support?
A 1996 Honda Accord was mainly used to demonstrate how to perform this task. Most radiator supports are welded in and have to be cut out and welded back in. If you are interested in learning more on how to do this type of repair and learn true body work and paint, follow this link: If you found this video valuable, give it a like.
Where is the coolant drain on a Volvo 940turbo?
You will not be able to remove all the coolant: it always seems as though about two quarts remains in the system. On the 940Turbo:the coolant drain is at the end of the short hose leading from the oil cooler, about five inches behind the oil filter beneath the car. It points down from the tubing on which it is mounted.
What kind of solder does a Volvo radiator use?
My own experience with Dexcool has been positive with one exception: the solder in a Nissen brass radiator began leaking . Dexcool is known to have problems with high-lead solders, and is also sensitive to air levels in cooling systems.
How do you replace a compressor in a Mitsubishi Turbo?
You should separate the compressor seal from the insert – they’re held together by a spring washer – your kit should have a replacement washer: Gently prise up the bronze seal using a flat head screwdriver inserted underneath at the gap: Out it comes.