Where are the computer code connectors on an Acura Integra?
Additionally, some connectors are located upside down, so some attention needs to be paid to this factor when trying to connect. The key thing to remember, is that since 1996, all auto computer code connectors are found somewhere inside the front passenger compartment. 1999-2001 Acura Integra.
How do you know if your Acura has a trouble code?
On all models, turn ignition On and observe red LED on front or top of ECU. The LED will indicate diagnostic trouble codes (DTCs) by number of flashes. In the event of a PGM-FI system malfunction, the Check Engine lamp will light and stay On. When this condition occurs, proceed as follows:
Where is the alternator sense fuse on an Acura Integra?
On 91–95 Integra models, remove back-up fuse from under hood fuse box for approximately 10 seconds to clear all stored DTCs. On 86–90 Legend models, remove alternator sense fuse in underhood relay box for 10 seconds to clear all DTCs. On 91–95 Legend models, remove No. 15 fuse from under dash fuse box for 10 seconds to clear all DTCs.
Where is the service check connector on an Acura?
Connect SCS service connector special tool No. 07PAZ-0010100, or equivalent, to service check connector located under passenger’s side of dash. Turn ignition On. MIL will indicate DTC (s) by number of flashes. Connect scan tool to 16-pin data link connector (DLC) located under glove compartment under a removable cover. Turn ignition On.
Where is the Diagnostic Code on a 1991 Acura Integra?
On all models except 1991 Integra, move front passenger seat to rear position. On 1991 Integra models, pull down passenger side carpet from under dashboard. On all models, turn ignition On and observe red LED on front or top of ECU. The LED will indicate diagnostic trouble codes (DTCs) by number of flashes.
On all models, turn ignition On and observe red LED on front or top of ECU. The LED will indicate diagnostic trouble codes (DTCs) by number of flashes. In the event of a PGM-FI system malfunction, the Check Engine lamp will light and stay On. When this condition occurs, proceed as follows:
On 91–95 Integra models, remove back-up fuse from under hood fuse box for approximately 10 seconds to clear all stored DTCs. On 86–90 Legend models, remove alternator sense fuse in underhood relay box for 10 seconds to clear all DTCs. On 91–95 Legend models, remove No. 15 fuse from under dash fuse box for 10 seconds to clear all DTCs.
Connect SCS service connector special tool No. 07PAZ-0010100, or equivalent, to service check connector located under passenger’s side of dash. Turn ignition On. MIL will indicate DTC (s) by number of flashes. Connect scan tool to 16-pin data link connector (DLC) located under glove compartment under a removable cover. Turn ignition On.