Where are the bolts on a Jeep Grand Cherokee?
There are two on each side of the Jeep. Remove the two bolts on each side of the rear frame using a socket and ratchet. Pull the bumper straight off the rear of the Jeep. Set the bumper aside. “Jeep Grand Cherokee Factory Service Manual”; The Chrysler Group; 1998
How do you remove a bumper from a jeep?
There are two on each side of the Jeep. Remove the two bolts on each side of the rear frame using a socket and ratchet. Pull the bumper straight off the rear of the Jeep. Set the bumper aside.
Where are the bumper brackets on a jeep?
Pop the connectors out with a flat screwdriver and set them aside. Locate the four mounting bolts for the rear bumper brackets under the back of the Jeep on the rear frame section. There are two on each side of the Jeep. Remove the two bolts on each side of the rear frame using a socket and ratchet.
What kind of Bumper does a Jeep Grand Cherokee have?
The Jeep Grand Cherokee has a bumper and fascia on the rear that uses a foam isolator to absorb impacts. Removing the fascia, absorber and bumper as a unit is possible or as separate components. Replacement bumpers are available from the dealership or through a collision parts supplier. In some cases.
How to replace a Jeep Grand Cherokee Limited bumper?
replacement bumper arrives with a black primer – you’ll first want to wetsand the whole piece with 600 grit sandpaper. Now wipe down the entire bumper with wax and grease remover. Apply wet with towel # 1, then dry with separate towel. Shake your can for about a minute. Spray from a distance of about 10 to 12 inches.
Can a strut bolt be removed from a jeep?
His jeep has 120k+ on it and that bolt was NOT coming out no matter how much we soaked it with PB Blast, 4ft breaker bar, hit it with air tools and heat from an acetylene torch….. it just was not enough! I guess being an ’06 with 120k didn’t help.
How to remove strut bolts from lower control arm?
Then feed the upper half of the strut assembly into the wheel well and line up the 4 bolts up top under the hood (we installed all 4 nuts up top to help keep the weight off the strut assembly, do NOT fully tighten) Next line up the clevis bracket and the bottom of the strut the best you can.