When to replace the clutch on a Volvo?

When to replace the clutch on a Volvo?

If the clutch is significantly worn, such that removing all the shims will not provide sufficient gap, then it may be time to replace the entire clutch assembly. With the replacement shims in place, hammer the clutch back onto the pulley and repeat step 4 to re-tighten the clutch back onto the compressor.

What kind of clutch does a Volvo V50 have?

This month, REPXPERT’s Alistair Mason replaced the clutch on a 2010 Volvo V50, which was fitted with a 1.6 turbo diesel engine, had covered slightly less than 160,000 miles and reportedly suffered from clutch ‘slipping’. Volvo added the V50 to its range in 2004 and the vehicle shares the same platform as the Ford Focus.

How to fix intermittent a / C in a Volvo?

Once the AC clutch obviously disengages itself and begins blowing warm air, turn off the AC with the button on the center console. Give the clutch a few minutes to cool down before turning the AC back on. If the clutch has cooled down enough, it should then reengage without any issues.

What should gap be between clutch and pulley on Volvo?

Using the T25 Torx driver, remove the screws which hold the wheel well liner in place and remove the liner from the vehicle. Measure the current gap between the clutch and the pulley. Factory gap clearance should be about 0.3mm all the way around. If the gap is any larger, then it is time to replace or remove the spacer shims.

How do you remove clutch plate from c Cluch?

Once you have some working space, tilt the compressor so the pulley faces the font of the vehicle and down a little bit. There is one bolt that holds the clutch plate on. You can remove it. You will need some sort of a puller to remove the clutch plate from the pulley. You can construct one from an old front brake pad fairly easily.

Where are the mounting bolts on a C Cluch?

To remove the clutch plate, you’ll need a little bit of space to work. Remove the serpentine belt and remove mounting bolts for the compressor. There are 4 bolts that hold the compressor in. They are all located on the side of the compressor that is towards the back of the car.

Why is my a / C not working in my Volvo?

If you find that your AC functions properly for only the first few minutes of use, the problem is most likely associated with the A/C compressor clutch. Being a wearable item, the compressor clutch is slowly being worn away during AC operation.