When does the Gen Trans Flt code flash?
Turn the key off and on two times within five seconds ending with the key in the on position. After five seconds, the service lamp begins flashing two-digit fault codes. If no faults are active, the service light will flash code 25 (no codes). This is also the procedure to enter, see Product Diagnostic Mode (PDM) on page 19 for details.
What does a general transmission fault code mean?
“general transmission fault”. It is the same as a “check engine” light. Here is a procedure to retrieve active codes; Place the shift lever in neutral. • Set the parking brake. • Turn the ignition key on but do not start the engine. If the engine is already running, you may
When does the fault code flash on an Eaton transmission?
Turn the key off and on 4 times within five seconds ending with the key in the on position. After 5 seconds, the Service light begins flashing two-digit fault codes. If no faults are active, the service light will flash code 25 (no codes). Two digit fault codes will be displayed in the gear display.
When to use fault code retrieval / clearing automated transmissions?
Fault Code Retrieval/Clearing An 88 may appear in the gear display which indicates self testing. *This code only set inactive. Driving Tips The clutch is only needed at Start-up, when selecting a starting gear, and when stopping. “D”, “M”and “L” can be selected at any speed.
When does the service light flash no codes?
If no faults are active, the service light will flash code 25 (no codes). This is also the procedure to enter, see Product Diagnostic Mode (PDM) on page 19 for details.
When did the Navistar Lonestar chassis come out?
SERVICE MANUAL SERVICE MANUAL SECTION LoneStar® and ProStar® Chassis Built January, 2007 and After — ELECTRICAL CIRCUIT DIAGRAMS Model: LoneStar Model: ProStar Start Date: 01/15/2007 S08339 02/17/2010 S08339 Copyright©02/17/2010 Navistar, Inc. LoneStar® and ProStar® Chassis Built January, 2007 and After — ELECTRICAL CIRCUIT DIAGRAMS i