What was the transmission fault on a 1998 Jaguar XK8?

Jaguar XK8: 1998 Jaguar XK8 Transmission Fault. Code came… Transmission started to go in first, made a clunk, then threw a CEL and Transmission Fault light. OBD codes came up P1722 Stall Speed … read more Vocational, Technical or Tra… 97 Jaguar XK8. When stopped at a stoplight (slightly upgrade 39;97 Jaguar XK8.

What are the VIN codes on a 1997 Jaguar XK8?

My 1997 Jaquar XK8 has the following codes: P1730, P0790, P0715, P1731 and P1722. FYI: It was driving like a dream and the next day would not … read more Vocational, Technical or Tra… Vocational, Technical or Tra… I just purchased a 1997 xk8 convertible with 75,000 miles on it.

Which is the best code for Jaguar check engine light codes?

P1188O2 Sensor Heater Circuit Resistance P1189O2 Sensor Heater Circuit Low Resistance Fault 1 P1190O2 Sensor Heater Circuit Low Resistance Fault 2 P1191O2 Sensor Heater Circuit Open – HArdware Fault P1192O2 Sensor Heater Circuit Shorted P1193O2 Sensor Heater Circuit Open – Inferred Fault P1194O2 Sensor Heater Circuit Resistance Fault

Where are the fuses on a Jaguar XK8?

Check FUSE BOX “A” (under bonnet, near strut on passenger side) fuse number 1, 10amp (Transmission Control Module). Again, check for tight, clean contact. Finaly FUSE BOX “D” (in the boot near batterty) fuse number 22, 5amp (Alternator, Battery Sense Input).

What causes a Citroen XK8 gearbox to fail?

There is an outside chance the ignition switch could be faulty. Some cars (Citroen) suffer from overload which burns out the switch, which in turn causes the heated screen, heater blower and power steering to fail. Good luck. OK, thanks for the pointers, I checked all the fuses and all OK and no corrosion.

What causes a transmission fault in a Jaguar?

It’s also possible you have a leak so the compressor is unable to maintain the ride height as the compressor has a on/off duty cycle to stop it burning itself out. Sadly the compressor failure is the more common fault.

Why is my XF Jaguar 3.0L not shifting?

Click to expand… I own a 2010 xf jaguar 3.0l automatic recently the gearshift could not come out and I phoned the dealership and they advised to replace the whole module which I did. Then after the module the car started taking too long intermetantely to shift.

Are there any problems with the Jaguar XJ transmission?

If you’ve had any difficulty with the transmision in your XJ series car, please tell us about it. No really problems. There is a recall out for a programming issue. Other than that the cars has been great. I have a 1998 XJ V8 vanden plais. Last spring at 80,000 I had a rebuilt transmission installed from a transmission shop.

Why is my 2000 XJ8L on high gearbox temperature?

I have a 2000 XJ8L with 119,000 miles on it and prior to me replacing the throttle body I was receiving the high gearbox temperature, failsafe mode and then the after awhile the limp mode message would eventually come up and the car would not operate properly.

What causes a 2004 XJ8 to not start?

I have a 2004 XJ8. When shifting from Drive to Park (brake pedal depressed), the shifter moved into park but the transmission went to reverse. The shift lever will not move out of park, but the car would drive backwards with the break released. Shut the car off, now it won’t start.

Can a 98 XJ8 shift into a 4th?

MY 98 xj8 does not shift into 4 or 5th ( higher than 3rd). In drive, it runs through 1St 2 nd and 3rd, then at 2200 rps it disengages and the trans fault lights up. If I start on the other side of the j gate in 3rd its stays engaged. 4th is the same as drive.

When to change the plugs on a 2000 XJ8 Trans.?

At 100,000 miles one is supposed to change plugs on a 2000, and when they change them, they are supposed to look at the chains. By the way, when a 2000 XJ8 trans. starts to go, it moves into a special zone…I believe it’s the third gear called something like limp home mode.

What is fault code 14 on a Jaguar?

The Climate Control fault code 14 is for a lack of coolant temperature signal to the Climate Control Module, so I think we can assess that as as a collateral fault that will go away when the P1638 fault is cleared. The P1638 fault is caused by one of the following (according to Jaguar!)

What kind of fault is p1638 on a Jaguar?

P1638 is a Controller Area Network fault that should be evidenced by having no temperature or engine speed info displayed. IMO it’s probaby associated with the 0706 fault and it would be best to leave it until that fault is cleared.

What is the diagnostic code for a Jaguar check engine light?

Refer to our Generic OBD II code list for definitions on all other Jaguar diagnostic trouble codes. Manufacturer Specific Codes P1000OBD Systems Readiness Test Not Complete P1104Mass Air Flow Sensor Circuit Ground – Read Our Article On Automotive Circuit TestingFor Help With This Jaguar Check Engine Light Code P1111System Pass

How to remove the intake duct from a Jaguar?

Remove the intake duct. With assistance, visually observe throttle butterfly operation as the ignition is switched ‘ON’ for the first time. Throttle butterfly should fully close, then immediately open to the idle position. Did butterfly stick closed? Switch ignition ‘OFF’. Lightly press throttle butterfly with finger to the fully closed position.

How to know if your Jaguar is on or off?

Raise hood and fit fender protection covers. Remove the intake duct. With assistance, visually observe throttle butterfly operation as the ignition is switched ‘ON’ for the first time. Throttle butterfly should fully close, then immediately open to the idle position. Did butterfly stick closed? Switch ignition ‘OFF’.

What are the code for poor idle on a Jaguar?

I should note that the poor idle still existed. The codes I got were P0300, P1316 and P1121 ABS Traction control, Transmission trouble and Failsafe cleared the codes and drove it home with no problems. I removed the throttle body when I got home and to my surprise I saw the throttle position sensor case had seemed to come apart.

Why does my Jaguar XJ8 have low coolant levels?

Cooling issues on pre 2000 cars – including actual, not indicated low levels – can be caused by waterpumps loosing efficency. With the engine stone cold open the header tank, start the engine and rev up to 2000-3000 rpm. You should see a reasonable flow of water into the tank.

What was the problem with the intake manifold on my Jaguar?

Reinstalled the intake manifold, NO JOY! I took the car into a local shop who had a smoke tester and we found the problem, I had a cracked intake manifold! So, I ordered a used intake manifold and had to wait for the second one to come in because the first one was not going to work.

Why is my jagrepair transmission shifting so poorly?

Several months ago, after I got my transmission shifting problem fixed, I noticed that my car was idling poorly and it was getting progressively worst so I began my quest to fix the problem. I first thought it was the plugs because they had been in the car for several thousand miles.

What causes a vacuum leak in a Jaguar?

Took it back for another leak test (smoke) and found a slight leak under the TB where the throttle elbow hose connects. This was after the pressure was increased a little. I am getting an “O” ring that should take care of the leak. I fixed all the leaks and I can say at this point NO VACUUM LEAKS!

Why does my Jaguar have a restricted performance error?

What is the Jaguar Restricted Performance error? With the Restricted Performance error message, the car is indicating that the engine management system has gone into a “limp” mode to protect certain systems and components. This changes depending on the system or components being protected.

What are the trouble codes for a Jaguar?

So to be 100% accurate you’ll need to refer to a service repair manual specific to your year/model/engine configuration such as Jaguar Technical Information System (JTIS) or possibly AllDataDIY. Other Jaguar-specific content on our site: Trouble codes that start with P0, P2, P34, B0, C0, U0, or U3 are all considered “generic”.

What should intake manifold pressure be on a Jaguar?

Intake manifold pressure is a steady 9.2 inHg and from what I gather it should be 15-20. Both upstream O2 sensors are both at .000 volts but they should be fluctuating between .1v and .9v. Both The car runs great but will not pass smog test…. The catalytic converter will not reset to be ready for a smog test.

Where to find check engine light codes on a Jaguar?

These are listed in numerical order for easy searching. When retrieving Jaguar check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.

What is the Mil code on a Jaguar X350?

Jaguar X350 ECU1 ($FD20) ECU1 (FD00) Codes? Hi all and good afternoon from a cold and windy Northumberland. The MIL has suddenly started appearing on my 2005 X350. I plugged the iCarsoft in and on the Jaguar specific search it came back with “Fault in communication with vehicle ECU”.

Why is my Jaguar XK8 not shifting gears?

The contact owns a 1998 Jaguar Xk8. While driving approximately 10 mph, the contact heard a loud sound underneath the vehicle. He was unable to shift into any gear. The failure occurred without warning. The vehicle was towed to an independent mechanic and it was discovered that there was a lock-up in the automatic gear box.

How to check for DTCs on a Jaguar?

END YES Use WDS to check for DTCs. Follow any guided routine associated with stored DTCs. From the feature content select engine/electronic engine control, press the guided tab then select electronic engine control relay. Alternatively you could view the EMS relay signal from the datalogger.

When did the Jaguar XJ long wheelbase come out?

Jaguar also released a long wheelbase version of the Sovereign in 1998. The difference being that the car is around 4 inches longer, with the rear doors being noticeably longer than the front; there is also correspondingly taller rear roof profile to provide additional headroom.

Is the Jaguar XJ being considered for merging?

‹ The template Infobox automobile is being considered for merging . › The Jaguar XJ (X308) is a full-size luxury sedan manufactured and marketed by Jaguar Cars for years 1997—2003 across two generations and featuring Jaguar’s AJ-V8 and Jaguar’s independent rear suspension.

What kind of engine does a Jaguar XJ8 have?

For the home market in September 2000, Jaguar began badging the XJ8 model as “XJ Executive”, and fitted as standard rain-sensing wipers, a CD player, cruise control, and rear parking sensors. The Sport model was equipped only with the 3.2 L normally aspirated engine, except Australia and the US that had the 4.0 L normally aspirated V8.

What’s the difference between the XJ8 and X308?

It offered stiffer suspension, sportier seating and interior colour combinations, and wider/larger wheels than the XJ8. The windscreen and rear window surrounds were painted matt black, as were the rain gutters and window frames for European markets (the US retains chrome surrounds). The radiator grille has metallic grey vertical slats.

What does the Jaguar gearbox fault light mean?

They will only be able to communicate with the engine control module but sometimes the code is stored in both the ECM and TCM. I will need the code number to be sure of the problem. It also can be caused by low fluid level but since there is no dipstick a dealer or shop will need to check the fluid level.

How does the jagrepair XJ Series sedan work?

In addition to the two networks , the XJ Series uses two serial data buses (ISO) for diagnostics, for the security system and for the programming of certain control modules. The XJ Series uses both power and logic grounds; however, it does not use a common logic ground stud connection as in previous Sedan vehicles.

When did the Jaguar XJ Electrical Guide come out?

Published by Parts and Service Communications Jaguar Cars Limited Publication Part Number – JTP 608 DATE OF ISSUE: SEPTEMBER 19971 XJ Series 1998 Introduction Electrical Guide Format This Electrical Guide is made up of two major sections.

https://www.youtube.com/watch?v=0rk-z-sYmy8

When do you have a ” transmission fault ” problem?

Suspension messages, you have symptoms of a failing air compressor, it has 3 minutes to get the car to the proper ride height, if it fails you get the message, by switching off and back on you are effectively giving it another 3 minutes to get the job done. As the weather gets colder the problem will occur more often.

Navigation