What should the rear speakers look like on a Toyota Camry?
If your upgrading the rear speakers in a Toyota Camry 2006-2011 (XV40) that is equipped with the factory premium JBL sound system, this tip may help. This is what the factory rear speaker should look like once removed. As you can see there will be four wires pinned in the factory speaker harness.
How do you remove speakers from a Camry?
Remove the black plastic speaker mount which is glued to the metal frame. Start from by pulling the tab away from the mount and gently peel the plastic away from the metal. 5. Cut the Speaker Dome From the Metal Speaker Frame
How to repair a broken retainer clip on a Toyota Camry?
Once the cover is removed, clear the mounting brakes of any broken retainer clip pieces. Slide the new speaker cover into place. Push on the cover until the speaker cover snaps into place. Toyota Camry, Avalon, Solara, Lexus ES300/330 Repair Manual 2002-2006; Jay Storer, John H. Haynes; 2009
When did the new Toyota Camry come out?
As of 2009, the Camry has gone through seven generations of redesigns, including a new hybrid design that combines a traditional gasoline and a new electric motor. While there aren’t too many components the average consumer would need to replace, the speaker cover might be one of them.
What does a rear rear speaker harness look like?
This is what the factory rear speaker should look like once removed. As you can see there will be four wires pinned in the factory speaker harness. You can easily identify the positive and negative wires by using a AA battery to pop the speakers, that is if the speakers are still functional.
Where is the negative tweeter wire on an alpine speaker?
You can then cut the tweeter wires off the main terminals on the new Alpine speaker. The wire with the black stripe on the left of this Alpine speaker should be connected to the negative tweeter wire, which should be the “Black” wire coming off the factory speaker harness.
How to install 6 x 9 speakers you installation and tips?
Shop all NVX products: https://www.sonicelectronix.com/m725-… Allyn walks you through installing 6″ x 9″ NVX car speakers in a vehicle’s rear deck lid, and he goes over some important tips and tricks that you should be aware of when replacing or upgrading your car speakers. Find products for your vehicle: http://www.sonicelectronix.com/afg?ut…
Can a 6×9 be replaced in a front door?
The process will be different for the front speakers. You will have separates/component speakers, so your mid 6×9 speaker and tweeter will be mounted and wired separately. The front door mid range 6×9 can be replaced with an aftermarket 6×9, but you will need the 6×9 speaker spacers.