What should I do if my Mazda battery keeps draining?
Regular batteries arent made for deep cycles. Either way the testing is free at Advanced and AutoZone. Check to make sure the trunk light is turning off when you close it. If you leave the car sitting for days at a time you should also change the security light to an LED which draws less power from the batt when it blinks.
Can a Mazda 3 have a dead battery?
Mazda’s are not known for battery problems. With that said, chances are either your new battery is not fully charged or it is a dud. It is most likely not fully charged. I suggest that you get it fully charged. As for the jumper, that is always a nice accessory to own regardless of which car you drive.
What should I do if my car battery is dead?
Your situation is odd. The battery should not be dead after one week, month or even 6 months if it’s new. Once you get the car started and it’s a good battery then the battery will charge itself to full assuming you drive the car long enough. Consider checking any interior lights are on.
What to do when your car engine stalls after a new battery?
Begin with the vehicle on level ground engine off (cold) with the emergency brake set. Step 1 – After a new battery has been installed, the engine could idle low or stall out altogether.
Mazda’s are not known for battery problems. With that said, chances are either your new battery is not fully charged or it is a dud. It is most likely not fully charged. I suggest that you get it fully charged. As for the jumper, that is always a nice accessory to own regardless of which car you drive.
Regular batteries arent made for deep cycles. Either way the testing is free at Advanced and AutoZone. Check to make sure the trunk light is turning off when you close it. If you leave the car sitting for days at a time you should also change the security light to an LED which draws less power from the batt when it blinks.
What causes a car battery to lose power?
Opening a door or turning the ignition on with the main battery disconnected can cause the battery in the device to lose power as well. Door modules Loss of express-up feature due to loss of stored “pinch point” Engine control module (ECM, PCM, VCM) Loss of learned idle speed which can cause a stalling condition.
How to fix stalling after replacing car battery?
Step 3: Disconnect the old vehicle battery and remove it. Step 4: Insert the new vehicle battery, use a battery brush to clean the cable ends and battery posts, connect and tighten the cables, and make sure the battery is secured in place. Step 5: Disconnect the memory saver immediately, before starting the car.
Your situation is odd. The battery should not be dead after one week, month or even 6 months if it’s new. Once you get the car started and it’s a good battery then the battery will charge itself to full assuming you drive the car long enough. Consider checking any interior lights are on.