What should I do if my Clutch gap is too big?
IF THE GAP CLEARANCE IS TOO LARGE, you then replace the spacer washer with another one to bring this CLEARANCE GAP back to the OEM specification gap (usually around .025-.030″) or you can file or grind down the OEM washer to accomplish this.
When to adjust gap on AC compressor clutch?
We will show how to adjust the gap on ac compressor clutch. When the clutch gets old it wears out and the gap increases as a result the a/cc compressor might not work. You can fix that by adjusting the gap. Also, if you replace the clutch you will need to set gap otherwise the ac compressor might not work.
What should the resistance of a clutch coil be?
If the battery voltage is present at the plug, test the coil for resistance. Resistance Test: Perform an A/C clutch coil resistance test with an Ohmmeter. Typically a clutch coil should be between the range of 2 to 5 Ohms, and any reading below 2 Ohms or over 5 Ohms indicates a bad coil.
What are the specs of a Nissan Murano?
Body-Colored Power w/Tilt Down Heated Side Mirrors w/Manual Folding and Turn Signal Indicator Fixed Rear Window w/Fixed Interval Wiper and Defroster Fully Automatic Projector Beam Led Low/High Beam Daytime Running Auto High-Beam Headlamps w/Delay-Off
What kind of interior trim does a Nissan Murano use?
Interior Trim -inc: Simulated Wood/Metal-Look Instrument Panel Insert, Simulated Wood Door Panel Insert, Simulated Wood/Metal-Look Console Insert and Chrome/Metal-Look Interior Accents Semi-Aniline Leather-Appointed Seat Trim -inc: diamond-quilted inserts
We will show how to adjust the gap on ac compressor clutch. When the clutch gets old it wears out and the gap increases as a result the a/cc compressor might not work. You can fix that by adjusting the gap. Also, if you replace the clutch you will need to set gap otherwise the ac compressor might not work.
IF THE GAP CLEARANCE IS TOO LARGE, you then replace the spacer washer with another one to bring this CLEARANCE GAP back to the OEM specification gap (usually around .025-.030″) or you can file or grind down the OEM washer to accomplish this.