What is the purpose of a rear axle vent tube?
the axle breather tubes are there to aloow for pressure changes in the axle when you go down the road the gears heat the oil causing it to expand when they cool off the oil contracts (makes sense right ?)
What happens when a differential breather kit is used?
170112 170112 No Would you like to tell us about a lower price? When drivetrain assemblies such as your vehicle’s differentials, gearbox and transfer case heat up under normal operation, the air inside expands and increases pressure.
Where are the breather tubes on the axle?
The rear breather tube attaches with that metal tab and a screw up in the passenger side rear corner, basically on the back side of the wheel well. Who needs a road…if there’s a perfectly good JEEP trail somewhere else!? Re: What are axle \”Breather Tubes\”?
How does the air vent in a differential work?
When drivetrain assemblies such as your vehicle’s differentials, gearbox and transfer case heat up under normal operation, the air inside expands and increases pressure. To vent this additional pressure, most factory differentials have a one-way valve mounted to either the assembly itself, or on a short extension tube close by.
How does ARB differentail axle breather kit work?
The ARB Differentail Axle Breather Kit eliminates this flaw by providing a high flow, with no back pressure, zero vacuum breather system. This is achieved with a high flow filter within a central manifold that will allow up to four drivetrain assemblies to be vented in one central location anywhere that will stay above water.
170112 170112 No Would you like to tell us about a lower price? When drivetrain assemblies such as your vehicle’s differentials, gearbox and transfer case heat up under normal operation, the air inside expands and increases pressure.
What are axle ” breather tubes ” and what do they do?
the axle breather tubes are there to aloow for pressure changes in the axle when you go down the road the gears heat the oil causing it to expand when they cool off the oil contracts (makes sense right ?) all that expansion and contraction would blow the seals out of the axles if they didnt have a vent as for the plugs they just allow air…
The ARB Differentail Axle Breather Kit eliminates this flaw by providing a high flow, with no back pressure, zero vacuum breather system. This is achieved with a high flow filter within a central manifold that will allow up to four drivetrain assemblies to be vented in one central location anywhere that will stay above water.
When drivetrain assemblies such as your vehicle’s differentials, gearbox and transfer case heat up under normal operation, the air inside expands and increases pressure. To vent this additional pressure, most factory differentials have a one-way valve mounted to either the assembly itself, or on a short extension tube close by.
Is a differential breather necessary?
Why are Diff Breathers important? Extended diff breathers are extremely important insurance for your 4WD if you drive through water. In essence, when you go through a puddle that is near or above diff height, you are dunking a hot differential into cold water.
What does a differential breather do?
A differential / axle breather serves the important purpose on a 4WD vehicle of venting the air pressure in your drivetrain assemblies such as differentials, gearbox and transfer case. This vacuum will close the one-way valve tightly shut causing air to be instantly drawn into the assembly through the axle/shaft seals.
Do differentials have vents?
The need for venting comes from the fact that the gear oil and air in the differential heats up and expands. It also contracts when it cools, which is why I think a check valve is a bad idea. The seals could be leaking because the vacuum in the diff is pulling in grime from outside and wearing them out.
How do you test a diff breather?
one way is to drain fluid with the fill port closed (crack open the fill first just in cast it is suck then close ti again) if the fluid comes out “goes glug glug glug….” as it alternately flows oil out then air back in then the breather still has the OEM evil little flapper or is otherwise plugged, if it pours out …
Do transfer cases have breathers?
the transfer case breather is on the front “half” of the split case. it’s on top on the left-hand side. Circled in red in the picture below.
What problem may be caused if the rear axle breather is blocked?
The breather valve on top of the axle, where fitted, can also become blocked. This causes oil and air to build up inside, which may force oil out of leak-prone places. Overfilling the axle with oil can also raise the pressure enough to cause leaks.
Does a rear end need to be vented?