What is mil in car diagnostics?
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction. This warning light can indicate almost anything from a loose gas cap to a serious knock in the engine.
How to read engine OBDII Codes without Nissan scan tool?
In this way, all the detected malfunctions are classified by their DTC numbers. The DTC 0000 refers to no malfunction. How to read the engine codes without a Nissan CONSULT or scan tool. (Set ECM in Diagnostic Test Mode II) Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds.
Where to find Nissan check engine light codes?
These are listed in numerical order for easy searching. When retrieving Nissan check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
What does code 12.4 mean on Nissan OBD?
Meaning: One red flash and two green flashes means code 12. 4. To clear the ECU of any trouble codes, move the switch to the “DIAGNOSTICS” position then back to the “ON” position and turn off the key.
How to find the service engine soon code?
Once the ECM is in Diagnostic Test Mode II, the “Service Engine Soon” warning light will start flashing. Count to flashes to determine the code A particular trouble code can be identified by the number of four-digit numeral flashes. The ‘zero’ is indicated by the number of ten flashes.
In this way, all the detected malfunctions are classified by their DTC numbers. The DTC 0000 refers to no malfunction. How to read the engine codes without a Nissan CONSULT or scan tool. (Set ECM in Diagnostic Test Mode II) Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds.
Where do I find the trouble code on my Nissan?
On all models, to erase DTCs using generic scan tool (GST), select mode 4. Place diagnostic switch in the Off position. Place ignition switch in the On position. Crank engine. Start and operate engine. The trouble codes will be displayed by the flashing Engine Control Lamp and the Overheat Warning Lamp and the Overheat Warning Buzzer.
What does a diagnostic code on a Nissan mean?
A diagnostic code is helpful when troubleshooting a particular problem that has occurred. After the trouble code is defined the problem can be repaired and rechecked. Early Nissan check engine lights are not used to blink out a trouble code like on most vehicles but instead use a mode and retrieval method.
What is the trouble code for a 1996 Nissan?
Trouble Code Info Model Year Engine identification System 200SX 1.6L 1996-98 GA16DE Nissan EGGS 200SX 2.0L 1996-98 SR20DE Nissan ECCS 240SX 2.4L 1996-98 KA24DE Nissan ECCS 300ZX 3.0L 1996 VG30DE Nissan EGGS