What is destination pattern?
Destination Patterns The destination pattern is used to associate a dial string with a particular telephony device. The call is routed when a dialed string matches a destination pattern. The POTS or VoIP voice port configuration determines the way the call is routed.
What is destination pattern 9T?
Indicates the interdigit timeout. The router pauses to collect additional dialed digits. For example destination-pattern 9T matches the digit 9 followed by zero or more digits- it will route the call only after the expiry of the inter-digit timeout.
What is MGCP profile Cisco?
The default (MGCP profile) command instructs the MGCP profile to use the default value of the specified command whenever the profile is called. This has the same effect as using the no form of the specified command, but the default command clearly specifies which commands are using their default values.
What is e164 pattern map?
’e164-pattern-map’ and ‘server-group’ command on Cisco IOS. Two commands: ‘e164-pattern-map’ (added from IOS 15.2) and ‘server-group’ (added from IOS 15.4) makes Voice Gateway/CUBE config dial-peers config very clean. With server-group, all the session target (session target ipv4:x.x.x.x) can be grouped together.
What are dial peers used for?
Dial Peer Overview Configuring dial peers is the key to implementing dial plans and providing voice services over an IP packet network. Dial peers are used to identify call source and destination endpoints and to define the characteristics applied to each call leg in the call connection.
What is a SIP dial peer?
SIP is selected as the call control protocol from inside a dial peer. SIP is requested by the session protocol sipv2 dial-peer subcommand. In this example, both dial peers include the session protocol sipv2 subcommand, and SIP is used when the destination pattern matches either dial peer.
Did Direct Inward Dialing?
Direct Inward Dialing (DID) is when a telephone service provider connects a block of telephone numbers to your company’s Private Branch Exchange (PBX). It allows businesses to set up virtual numbers that can bypass the main reception lines and go directly to a desk extension or group of extensions.
What is dial peer in Cucm?
A dial peer, also known as an addressable call endpoint, is a device that can originate or receive a call in a telephone network. According to this definition, there is one dial peer for each call leg (connection between two addressable call endpoints).
What is SIP dial peer?
What is a dial peer Cisco?
Dial Peer Overview Dial peers are used to identify call source and destination endpoints and to define the characteristics applied to each call leg in the call connection. This chapter contains the following sections: • Call Legs, page 1. • POTS Dial Peers, page 4. • Voice-Network Dial Peers, page 4.
What is default dial peer in Cisco?
dial peer 0
If a match is not found in the previous steps, then the default is dial peer 0. Because call setups always include DNIS information, it is recommended that you use the incoming called-number command for inbound dial-peer matching.