What is an ignition coil condenser?
Basically the function of a condenser in a coil ignition circuit is to reduce the spark at the contact points as they open in the distributor and thus minimise burning and pitting of the points. Arcing is caused by the effect of self induction in the coil as the points interrupt the flow of current.
How can you tell if an auto ignition condenser is going bad?
If you suspect the condenser is going bad, you can sometimes tell by watching the engine run while it is in idle. The point cover needs to be removed and some engines won’t run without it, but if the condenser is going bad, you are likely to see a large yellow spark jump between the two contact points.
How does a point ignition work without a condenser?
This probably wouldn’t be a danger, because without the condenser, the ignition won’t work. The condenser is charged up (voltage wise), by the current flowing from the coil because of the energy stored in the now collapsing magnetic field. This current flow quickly charges the capacitor, and then the capacitor then sends current back to the coil.
Why are the points on my condenser not working?
As the engine-driven distributor drive shaft rotates, a corner lobe of its cam pushes the contact breaker points open, breaking the primary circuit and preventing the primary coil from charging any further.
Where is the ignition igniter on a 1987 Toyota?
Locate the igniter. It is a 2-inch square box located either on the driver’s side fender well or on the side of the distributor. Inspect the electrical harness plug in the igniter. Notice that there are five wires in the plug. The only two that you are concerned with are the top and bottom wires to the extreme left side of the plug.
Locate the igniter. It is a 2-inch square box located either on the driver’s side fender well or on the side of the distributor. Inspect the electrical harness plug in the igniter. Notice that there are five wires in the plug. The only two that you are concerned with are the top and bottom wires to the extreme left side of the plug.
Where are the wires in an ignition igniter?
Inspect the electrical harness plug in the igniter. Notice that there are five wires in the plug. The only two that you are concerned with are the top and bottom wires to the extreme left side of the plug. The top wire is the signal from the computer, and the wire below it is the confirmation of firing going back to the computer.
Where is the igniter located on a Jeep Cherokee?
Locate the igniter. It is a 2-inch square box located either on the driver’s side fender well or on the side of the distributor. Inspect the electrical harness plug in the igniter. Notice that there are five wires in the plug.