What does error code P1682 mean?
ignition switch circuit
The P1682 code means that there is a difference in voltage between the ignition switch circuit 1 and circuit 2.
What does a p1682 error code mean?
A P1682 error code usually means that the ignition switch or either of its circuits, or both, are damaged. The ignition switch is responsible for providing electric current to the starter so that the engine can start. The ignition switch is sometimes part of an anti-lock theft system.
Where do the check engine lights go on a Jeep Wrangler?
Don’t go too slow, or it may not register. Once those steps are completed, all lights on the dash should turn on and six dashes should appear in your odometer. If your Wrangler has logged any check engine codes, they will display after the dashes refresh. The message “Done” will appear if your Jeep hasn’t logged any codes.
What is the engine code on a Jeep Wrangler?
By determining the engine code associated with the warning light you find the root of the problem. An engine code is also referred to as a Diagnostic Trouble Code, or DTC. Wrangler DTC codes can range from low battery voltage to sensor issues, depicted by a string of digits.
What does DTC p1682 stand for in ECM?
The second ignition 1 voltage circuit is supplied by the run/crank relay through a fuse, and is used to power the remaining internal ECM circuits. If the ECM detects a voltage difference between the 2 ignition 1 voltage circuits, DTC P1682 will set.
How to find out if your car has a p1682 code?
Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P1682 code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city.
By determining the engine code associated with the warning light you find the root of the problem. An engine code is also referred to as a Diagnostic Trouble Code, or DTC. Wrangler DTC codes can range from low battery voltage to sensor issues, depicted by a string of digits.
Don’t go too slow, or it may not register. Once those steps are completed, all lights on the dash should turn on and six dashes should appear in your odometer. If your Wrangler has logged any check engine codes, they will display after the dashes refresh. The message “Done” will appear if your Jeep hasn’t logged any codes.
The second ignition 1 voltage circuit is supplied by the run/crank relay through a fuse, and is used to power the remaining internal ECM circuits. If the ECM detects a voltage difference between the 2 ignition 1 voltage circuits, DTC P1682 will set.