What does a Gen Trans Flt code mean?
There is no charge for this service, but standard message and data rates may apply. “general transmission fault”. It is the same as a “check engine” light. Here is a procedure to retrieve active codes; Place the shift lever in neutral. • Set the parking brake. • Turn the ignition key on but do not start the engine.
How to troubleshoot Gen2 transmission fault code 64?
All rights reserved376 TRTS0940 Fault Isolation Procedures | Fault Code 64 Troubleshooting Gen2 ECA Fault Code 64 Troubleshooting Gen2 ECA 1. Record the transmission fault codes, FMIs, occur – rences, and timestamps from the Service Activity Report created during the Diagnostic Procedure. 2. Key on with engine off. 3. Connect ServiceRanger.
What does a general transmission fault code mean?
“general transmission fault”. It is the same as a “check engine” light. Here is a procedure to retrieve active codes; Place the shift lever in neutral. • Set the parking brake. • Turn the ignition key on but do not start the engine. If the engine is already running, you may
When to use fault code retrieval / clearing automated transmissions?
Fault Code Retrieval/Clearing An 88 may appear in the gear display which indicates self testing. *This code only set inactive. Driving Tips The clutch is only needed at Start-up, when selecting a starting gear, and when stopping. “D”, “M”and “L” can be selected at any speed.
When does the fault code flash on an Eaton transmission?
Turn the key off and on 4 times within five seconds ending with the key in the on position. After 5 seconds, the Service light begins flashing two-digit fault codes. If no faults are active, the service light will flash code 25 (no codes). Two digit fault codes will be displayed in the gear display.
What’s the warning triangle light on the dash?
The warning triangle light with the warn engine on the dash actually went out by itself today. Thanks for the update. Keep an eye on this as it may be that the ECM just needed to adjust to the new sensor values. If it happens again it might be a good idea to have the ECM reflashed/reprogrammed and updated to reset it to factory settings.