What are the torque settings for a KA20 Hardbody?
Crank shaft main bearings.46-52 Nm tighten in 2 or three stages.\015\012Con rod bearings 14-16 Nm1st step. 2nd step 39-45. Or if you have access to angle torque 60-65 degrees.
What kind of engine does the Nissan KA24DE have?
The KA24DE is a 2.4L inline four-cylinder engine that uses an iron cylinder block with an aluminum cylinder head. Part of the reason Nissan used an iron cylinder block was to save money.
What’s the difference between the KA24E and KA24DE?
As you may expect, these engines are very similar, but there are a few fundamental differences that separate these engines. The most significant difference is the cylinder head. The Ka24E was a single overhead cam engine with just three valves per cylinder, and the KA24DE was a dual overhead cam engine with four valves per cylinder.
Are there balance shafts in the Nissan KA24?
Even with its relatively large displacement, the KA24 did not implement balance shafts. Later versions of this engine used a DOHC design with four valves per cylinder which increased power and efficiency. Oddly enough, Nissan decided to use a shim-over-bucket configuration for the valve train instead of rocker arms.
The KA24DE is a 2.4L inline four-cylinder engine that uses an iron cylinder block with an aluminum cylinder head. Part of the reason Nissan used an iron cylinder block was to save money.
As you may expect, these engines are very similar, but there are a few fundamental differences that separate these engines. The most significant difference is the cylinder head. The Ka24E was a single overhead cam engine with just three valves per cylinder, and the KA24DE was a dual overhead cam engine with four valves per cylinder.
How manybhp does a KA24DE SR20DET have?
Although many people upgrade to the SR20DET engine, many stay with the KA24DE because of its larger displacement. A naturally aspirated built can reach up to 200whp (230bhp), but it isn’t cheap. This kind of build requires full bolt-on, ported and polished head, bigger cams, and possibly a higher compression ratio.
How big is the intake valve on a Nissan KA24E?
Intake valves are 34.0 mm (1.34 in) in diameter and the exhaust valves are 40.0 mm (1.57 in). The intake valve duration is 240°, valve lift is 10.4 mm (0.409 in); the exhaust valve duration is 248°, valve lift is 10.4 mm (0.409 in). The KA24E rev limiter is set on 6,500 rpm.