What are the problems with my Nissan Almera?

Changed timing chain and sensors car wont start. Fuel and spark working. Got nats codes 1610 & 1612 engine cranks but no start no spark at plugs. Nats light on dash continuously flashes. Any ideas thanks The engine light came on, l scanned to find fault on bank 1 sensor 1which I replace, only for it to show bank 2 sensor 2 again.

Why does my Nissan Almera make a hissing noise?

The engine is running rough, and there is a hissing noise coming from it, although there are no problems revealed when you do a fault check. Most likely, this is a problem with your airflow meter.

What are the Nats codes for Nissan Almera?

Got nats codes 1610 & 1612 engine cranks but no start no spark at plugs. Nats light on dash continuously flashes. Any ideas thanks The engine light came on, l scanned to find fault on bank 1 sensor 1which I replace, only for it to show bank 2 sensor 2 again.

What to do when immobilizer light goes off on Nissan Almera?

This is a sensor issue, so it’s very easy to do yourself. Change the sensors on the crankshaft and the camshaft with replacements here, and then reset your car’s computer. This should resolve the issue, and your immobilizer light should turn off.

When does the Intelligent Key Blink on a Nissan Sentra?

For vehicles without Intelligent Key: This light blinks whenever the ignition switch is placed in the LOCK, OFF or ACC position. For vehicles with Intelligent Key: This light blinks when the ignition switch is placed in the LOCK position with the key removed from the ignition switch.

What should I do if my Nissan immobilizer fails to start?

If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device on the key ring), restart the engine using the following procedures. 1. Leave the ignition switch placed in the ON position for approximately 5 seconds. 2.

Why is the Nissan immobilizer light still on?

This function indicates the NISSAN Vehicle Immobilizer System is operational. If the NISSAN Vehicle Immobilizer System is malfunctioning, the light will remain on while the ignition switch is placed in the ON position. If the light still remains on and/or the engine will not start,…

Can a Nissan Car start without a key?

The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key.

Can a Sentra sensor be replaced in a Nissan Almera?

You can try replacing yours with a Sentra or an Altima sensor, good luck. Good afternoon, I have a Nissan Almera 2007, which starts but does not accelerate. The first failure that appeared and was detected by the scanner was a crankshaft sensor damage.

How can I tell if my Nissan Almera starter is bad?

You can try and diagnose it by attaching a multi-meter to the earth battery terminal and a clean earth connection on the starter. Switch to at least 12V scale and operate starter. If you see more than a minimal voltage you’ll know that’s the problem (somewhere).

What was the facelift of the Nissan Almera?

A year further down the line, Nissan facelifted the Almera, changing the bumpers and grille for a more Primera-like appearance. The trim designations were altered, pricing was made more aggressive, the engines were tweaked slightly and the Primera’s N-FORM dashboard was fitted to all but the base models.

Is there a recall on the Nissan Almera N16?

Just in case it’s of interest/relevance to anyone else, I thought I’d report that my late-2004-registered Nissan Almera N16 hatchback was recalled last week to have its headlights replaced. The explanations of why were a little confused.

Why does my Nissan Almera stutter when I Rev the engine?

Your Almera starts fine, but it stutters and sometimes cuts out when you rev the engine. This could be a variety of issues. Your first step should be to check the airflow sensor and then test that the fuel pump is working correctly.

Is there a problem with the timing chain on a Nissan Almera?

The timing chain is a known issue on the Almera. The timing chain will need to be adjusted, most likely tightened. This should fix your problem. Watch the video below on how to carry out this repair: It is known on the Almera for the electric windows to fail.

What’s the problem with my Nissan Almera engine?

I am driving a nissan almera 2003 model, the car is starting but when i accelerates it only comes up to 2500 revs and then it starts jerking. I replaced the MAF sensor as well as the throttle position sensor, but its still doing the same thing, please help Even though the four coils are working, coil number 1 has no spark.

What to do if your Nissan Almera stalls?

The vehicle occasionally stalls and starts without a problem. But there are some other occasions, which have been more frequent lately, in which the engine does not start working again after it stalls. You need to change both the crankshaft and camshaft sensors and then reset your computer.

The engine is running rough, and there is a hissing noise coming from it, although there are no problems revealed when you do a fault check. Most likely, this is a problem with your airflow meter.

Why is my gearstick on my Nissan Almera shaking?

Check your engine mounting rubbers are still intact. One wee thing with these engines – the camshaft is driven by chain, which may stretch a little. There are two sensors – camshaft and crankshaft. If the timing chain wears, the sensors come out of phase, and the only cure is timing chain replacement.

How to reset the airbag on an Almera?

1. Turn the key from off to on. 2. Watch the airbag light closely. It will stay on for a few secs. and then as soon as it blinks off (the start of the flashing), turn the key off instantly. 3. Count to 5 (1 Mississippi, 2 Mississippi . . . .) 4. Repeat steps 1-3 two more times until you have done the cycle three times. 5.

Navigation