What are the ends of a throttle cable called?
The housing has a threaded length adjuster and end caps (called ferrules) at the ends. Each end of the wire has a soldered-on fitting, which is usually a barrel type on dirt bikes. Some applications utilize an aluminum elbow to hold the cable at a strict bend for routing purposes. (2) Housing.
What size is motorcycle throttle cable?
Inner Wire Diameter: The diameter of the inner wire, 1.2mm & 1.5mm commonly used for throttle and choke cables, and 2.0mm, 2.5mm, 3.0mm used on clutch and brake cables.
Can you solder a broken throttle cable?
Now, using pliers to hold the cable, solder the throttle end with the copper tubing until the tubing is filled with solder. You will know there is enough solder when some of it starts crawling up the throttle cable. Your throttle cable has been repaired and is ready to use.
Can you cut a throttle cable?
The best way is wrap a bit of tape on it, mark the cut, then use the thinest cut off wheel ya got on it. After the cut carefully unwrap the tape and slid it in the fitting and tighten the allen screw. Done and simple.
Where can I get a good throttle cable?
Hit the gas with high-performance motorcycle throttle cables direct from J&P Cycles. We’re the world’s largest aftermarket motorcycle parts and accessories store, which means if there is a quality universal throttle cable out there, chances are we probably stock it.
How does a dual throttle cable work on a motorcycle?
Dual throttle cable setups have two cables and use a throttle sleeve that accepts two cables. One cable that pushes and another that pulls when you twist the throttle. The push side of the cable helps ensure the handlebar throttle closes completely when you release the throttle.
Do you need a clutch cable for a motorcycle?
While you’re replacing hand control components, be sure to add Motorcycle Brake Cables and Motorcycle Clutch Cables to ensure everything is snapping and returning smoothly.