What are the different types of IAI error codes?
Demand Error It was a unit with CPU of the driver etc. , and reading was demanded for the one of the unmounting. Sum Check Error (The IAI protocol is received.) Checksum in reception is invalid. Header Error (The IAI protocol is received.) The header in reception is invalid. The receiving address is invalid. ID Error (The IAI protocol is received.)
When is interference check zone no.is invalid?
Interference check zone No. is invalid – only new SCARA. When the interference check zone invades, the error type is invalid. – only new SCARA. Check for noise, disconnected equipment, and improper communication setting.
What does a code p0400 on an EGR mean?
A code P0400 may mean that one or more of the following has happened: Plugged EGR passage which restricts the flow of exhaust gasses Faulty EGR solenoid wiring/harness
What are the trouble codes for Kia cars?
Kia Codes; Trouble Code Fault Location Probable Cause; P1000 – P1099 (Fuel and air metering and auxiliary emission control) P1000: System diagnosis incomplete: Drive cycle incomplete, ECM: P1100 – P1199 (Fuel and air metering) P1100: Manifold absolute pressure (MAP) sensor- for EGR system – circuit malfunction: Wiring, MAP sensor: P1102
What is the OBD2 code for a Kia?
OBDII Kia Code Definitions. Be sure to double check the codes. Anything P1000 to P1999 or P3000 to P3400 will be Manufacturer specific and may not match the ones listed here. Check specific manufacturer pages on the site, as some of them, we list the OBD2 codes on those pages for those specific vehicles.
What is the trouble code on a 1995 Kia Sportage?
TEST and ground terminals. On 1995 Sportage models, turn ignition to On, but do not start engine. On other models, start and warm engine, then run at 2,000 RPM for 3 minutes. Diagnostic trouble codes will be displayed as a series of long and short flashes on the malfunction indicator lamp (MIL).
Where to find check engine light code on Kia?
When retrieving Kia check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.