What are the alignment specs for a 1967 Mustang?
Please align to these specs “1967-1970 Mustang, Falcon & Cougar Performance Alignment with or without UCA drop”. These specifications are in order of importance. 1. NO more than .25 degrees difference between driver’s side and passenger’s side. 2. +2.0 to +3.5 degrees caster. 3. -.5 to 0 degrees camber. No positive camber, please.
Why is my front end alignment not accurate?
Contacting the tire isn’t accurate because of the tire bulge at the bottom. Remove or add shims equally to both upper A arm mounts for each wheel until the wheel is perfectly vertical or just a hair tilted out. Having camber or caster perfect isn’t real important just to drive to the alignment shop.
What are the alignment specs for a Camaro?
Caster 5 deg positive, or as much positive as you can achieve up to 5 deg, can use .5 deg additional positive on the passenger side to compensate for road crown. A common setting would be: LF 5 deg positive, RF 5.5 deg positive. -1 deg for street, Autocross, and Open Track, this will wear the inner tire tread if you drive a lot of freeways.
How much toe in do you need for front end alignment?
You must have a slight amount of toe-in or the car will want to go anywhere but straight. It’s the most critical adjustment but the easiest to adjust. Toe is the difference in measurement between the center of the very front of the tires vs. the center of the very back of the tire. Factory spec is 1/8″ to 1/4″ toe in.
Please align to these specs “1967-1970 Mustang, Falcon & Cougar Performance Alignment with or without UCA drop”. These specifications are in order of importance. 1. NO more than .25 degrees difference between driver’s side and passenger’s side. 2. +2.0 to +3.5 degrees caster. 3. -.5 to 0 degrees camber. No positive camber, please.
What are the specifications for front wheel alignment?
The caster specifications shown are with the frame level from front to rear. Measure front to rear frame angle when checking alignment and compensate as follows: If the front of the frame is lower than the rear, the actual caster angle is obtained by adding the frame angle to the caster angle as shown on the checking equipment.
What are the wheel alignment specs for a Camaro?
Wheel alignment specs with adjustment illustrations are available for all Camaro models HERE 1970-1981 Camaro (including Z28 Models) The Second Generation Camaro has a short-long arm (SLA) front suspension, which is fully adjustable for Camber, Caster, and Toe. Camber and Caster are adjustable with OE shims at the upper control arm.
What are the front axle alignment specifications for a F-350?
Vehicle Model Front Axle Capacity Alignment Factors CHECKING SPECIFICATIONS Optimum Resetting Specifications Desired F-350 (3) 3800 Camber 0° +½° F-350 (3) 3800 Toe-in 1/16″ ⅛” F-350 (3) 3800 King Pin Angle – 4°