How to troubleshoot a mini chopper pocket bike?
Tighten the idle screw no more than 2 turns at a time to adjust properly. You will need to adjust the idle a few times until you find the perfect setting for your bike. Loosen the idle screw. Too much throttle is being given to the bike, which makes it want to run on its own. DO NOT LOOSEN TOO MUCH.
What kind of parts do you need for a mini chopper?
Replacement and performance parts for the 2-stroke and 4-stroke Mini-Choppers. Choose from parts such as a new dual-rear wheel assembly, brakes, chains, engine parts, performance parts and much more.
Where is the throttle on a pocket bike?
On the right side of your bike, where your throttle is located, there is a bolt (as shown in image6 with red arrow below). You would unscrew the bolt and place it in any of the slots located above (as shown with the yellow arrows). This would limit the distance the throttle can be pulled back, thus limiting the speed.
Where to put choke lever on pocket bike?
In certain weather conditions, you may put the choke lever in the middle or lower position to help make it easier to start. Starting may require several tries when the bike is still new. After break-in, the bike will start up with only one or two pull procedures.
What kind of parts do I need for my Mini Chopper?
Mini Chopper Parts – We carry a complete selection of stock parts, oem parts and performance parts for pocket bikes, gas scooters, mini choppers, dirt bikes, go karts, electric scooters, motor scooters and mopeds.
Tighten the idle screw no more than 2 turns at a time to adjust properly. You will need to adjust the idle a few times until you find the perfect setting for your bike. Loosen the idle screw. Too much throttle is being given to the bike, which makes it want to run on its own. DO NOT LOOSEN TOO MUCH.
What kind of sprocket does a mini chopper use?
15 tooth sprocket fits a 420 chain and has a 20 mm inner shaft hole. 15 tooth sprocket fits a 428 chain and has a 20 mm inner shaft hole. Exhaust pipe for 33cc to 36cc engines. Engine 196cc 6.5hp California… California Approved 196cc Engine 6.5hp
What do you need to know about razor Mini Chopper?
Seat with Razor® logo for the Razor® Mini Chopper electric bike. Gas tank for the Razor® Mini Chopper electric bike. Handlebar grip set for the Razor® Mini Chopper electric bike. Handlebar grip set for the Razor® Mini Chopper electric bike. Pleasant sounding and attention grabbing bell sound.
What happens if I Break a part on my Pocket Bike?
If you happen to break a part on your bike, depending on which part, it can be covered under the 6-months parts replacement warranty. If you have purchased your bike within 30 days, we will replace all parts to you at no charge including shipping cost. WEAR AND TEAR ITEMS (such as tires, brakes, body kit, etc…) not included!
What’s the best way to set up a pocket bike?
Turn the gas valve in the vertical position opening the gas to the bike (as shown in image2 with yellow arrow, the gas valve in the UP position). Wait 3-4 minutes, while sometimes rocking the bike back and forth to allow the gas to flow through the fuel lines for the first time.
On the right side of your bike, where your throttle is located, there is a bolt (as shown in image6 with red arrow below). You would unscrew the bolt and place it in any of the slots located above (as shown with the yellow arrows). This would limit the distance the throttle can be pulled back, thus limiting the speed.