How to stop an oil leak on a 2007 Pontiac G6?
1. Remove oil filter, let drain then plug filter housing with paper towel to stop leak. 2. There are four bolts which need removed. 3 for the filter and one for a plate covering the filter. 3. remove the two easiest bolts to access, then remove the bolt holding the plate. 4.
Are there problems with the GM 3.1L V6 engine?
The only “problem” block in the 3.1L V6 engine family to watch out for was the one used in some 1988-’90 FWD cars and minivans, casting #10065459. This particular casting tended to develop cracks near the center cylinders.
Can a bad oil pressure sensor cause an oil leak?
The gauge tells the driver what the current oil pressure is. If you ever notice the oil pressure gauge indicating a strange pressure reading, then it definitely means your oil pressure sensor is bad. Either that or there is a possible oil leak somewhere in the system. Driving with a bad oil pressure sensor is extremely unwise.
Are there any problems with the 2007 Pontiac G6?
CarComplaints.com Notes: Unfortunately the 2007 Pontiac G6 continues a serious trend of steering problems from the prior model year. No one has added a helpful site for this 2007 G6 problem yet.
Are there any recalls on 2004 Pontiac Grand Prix?
The 2004 Pontiac Grand Prix is among the 1.4 million vehicles GM is calling back over potential oil leaks that could cause a fire. For the third time in seven years, General Motors is recalling cars that can leak oil and catch fire, in some instances damaging garages and homes.
What causes a misfire on a GM 3.1L V6?
The waste-spark DIS ignition system on the 3.1L is similar to that used on other GM V6 engines. It has been a fairly reliable ignition system, but at high mileage, it can develop problems like any other ignition system. Ignition misfire can be caused by worn or fouled spark plugs, bad plug wires, weak coils or faults in the ignition control module.
What causes oil to come out of engine?
All have 3.8-litre V6 engines. Over time, a valve cover gasket can degrade, allowing oil to seep out. Under hard braking, oil drops can fall onto the exhaust manifold and catch fire. Flames can spread to a plastic spark plug wire channel and the rest of the engine.
What’s the difference between 1992 and 1995 GM engines?
The major differences to watch out for would be the A/C compressor and starter mounting bolt holes, and sensor mountings. The 1988-’92 engines did not use a cam position sensor, some of the 1993-’94 engines had cam sensors and some did not, while all of the 1995 and later engines had cam sensors.
Where is the heat indicator light on a Pontiac G6?
Press the top of the switch to turn the feature on. The seat will heat to the high setting. The indicator light above the switch will be lit next to the number 2. Press the top of the switch again to go to the low heat setting. The indicator light will be lit next to the number 1.
What should I do if my oil pressure light goes out?
Make sure the oil light goes off in this time. Turn off the engine, then restart it and see if the light goes out at idle. Drive the car at highway speeds. See if the light comes back on. If it does, then I’d assume that the oil pressure switch is dead. Replace it with a new one.
What is the problem code for Pontiac check engine light?
P1113Intake Resonance Switchover Valve Circuit P1114Engine Coolant Temperature (ECT) Sensor Circuit Intermittent Low Voltage – Read Our Article on Automotive Circuit TestingFor Help With This Pontiac Trouble Code