How to loosen the clutch on an AC compressor?
5. in picture #1 you can see two long bolts that hold AC compressor, you can use 16mm deep socket with 3/8 drive from the top to loosen top bolt and the same for the bottom bolt but from the bottom side. (you don’t even have to remove the plastic side splash shield and the plastic cooler hose).
How do you remove a clutch nut from a car?
You may be able to use an impact tool to shock it loose if the engine is on the bench. If the engine is in the frame, remove the bolts and springs and then the plates. If the engine is on the bench the whole plate pack can be lifted out as a unit if you leave the springs and nuts in place. 10) When rebuilding, just reverse the procedure.
How do you remove a pulley from a compressor?
Remove the serpentine belt and unbolt the compressor from it’s mounts and tilt it up so you can get to the front easier. Use the clutch removal tool to pull off the clutch. Remove the large snap ring in front of the pulley. Spray some WD40 in the hub area and remove the pulley from the compressor.
How to remove the clutch nut on a wingovation?
If the engine is in the frame, remove the bolts and springs and then the plates. If the engine is on the bench the whole plate pack can be lifted out as a unit if you leave the springs and nuts in place. 10) When rebuilding, just reverse the procedure. Use a new locking washer, don’t forget the Belville washer which goes in with the convex surface
Is an AC compressor supposed to spin with the clutch?
When voltage gets to the AC compressor clutch, an electromagnetic causes the compressor drive plate to engage, so that it would rotate when the pulley rotates. Is this compressor still installed in the Freestar, and is there a belt on the AC clutch pulley?
How do you remove clutch from GM A / C compressor?
Remove the serpentine belt and unbolt the compressor from it’s mounts and tilt it up so you can get to the front easier. Use the clutch removal tool to pull off the clutch. Remove the large snap ring in front of the pulley. Spray some WD40 in the hub area and remove the pulley from the compressor. It’s best to use the universal puller.
How do you replace the AC clutch on a car?
The objective is to replace the AC clutch on the car. Remove the AC compressor’s front and rear bolts only. Lift the front of the compressor up to clear the top radiator support. Maintain the compressor in that position by placing a block of wood between the front of the compressor and the top of the engine.
What causes a locked clutch on an AC compressor?
The AC compressor exhibited no unusual symptoms that would explain the locked clutch, there was no bearing failure, no unusual noise, no smoke, no fire. On the contrary, the AC continued to work properly.