How to install all balls racing starter motor?
Remove the contents of your ALL BALLS RACING starter motor kit. Remove the contents of your ALL BALLS RACING jack shaft kit. Arrange the components in an organized manner for easy installation. Note: wait to do this until the old parts are removed and you are ready to begin installing the new components. Remove the seat bolt. Remove the seat.
How do you install a new starter motor?
Apply a thin coat of grease to the new oil seal lips. Install the new jack shaft oil seal into the left case half until it is fully seated. Note the direction and order of your new jack shaft and parts. Install the the splined washer onto the new starter motor, a small dab of grease will help hold it in place.
Where can I get a high performance starter motor?
Get your High Performance Starter Motor and Jack Shaft kit from ALL BALLS RACING. Remove the contents of your ALL BALLS RACING starter motor kit. Remove the contents of your ALL BALLS RACING jack shaft kit. Arrange the components in an organized manner for easy installation.
Where do you put the oil seal on a starter motor?
Remove the starter motor. Drive out the old jack shaft oil seal and note the direction of the seal for installation. Apply a thin coat of grease to the new oil seal lips. Install the new jack shaft oil seal into the left case half until it is fully seated.
How does the armature of a starter motor work?
When the starter switch is operated, the armature shaft revolves, causing the pinion, owing to its inertia, to revolve more slowly than the shaft. Consequently, the pinion is propelled along the shaft by the thread into mesh with the flywheel ring gear.
Remove the contents of your ALL BALLS RACING starter motor kit. Remove the contents of your ALL BALLS RACING jack shaft kit. Arrange the components in an organized manner for easy installation. Note: wait to do this until the old parts are removed and you are ready to begin installing the new components. Remove the seat bolt. Remove the seat.
What kind of pinion does a starter motor use?
Perhaps the two most commonly used are the inertia engaged pinion and the pre-engaged pinion methods. In inertia engagement the drive pinion is mounted freely on a helically threaded sleeve on the armature motor shaft.
Where is the starter motor on a car?
Remove the coupling and the old jack shaft. Locate the starter motor on the right side of the machine. Pull back the rubber boot, remove the lock nut and free the starter motor cables. Disconnect the solenoid connector. Remove the 2 starter motor mounting bolts. Some models may require the removal of an exhaust bracket. Remove the starter motor.