How to check the deflection of a Kawasaki clutch?
The belt deflection can be measured by placing a straight edge “ruler” ontop of the belt from the secondary to the primary. Using approx. 13 lbs of pressure with your finger, push down on the belt in the center between the primary and secondary.
Can you reset the belt on a Kawasaki Prairie?
Learn how to reset your ATV belt check light yourself. The Kawasaki Prairie 360, Kawasaki Prairie 650, Kawasaki Prairie 700, Kawasaki KFX700 V-Force, Kawasaki Brute Force 650, and Kawasaki Brute Force 750 ATVs are fitted with drive belt alert systems.
How do I check my belt on my Kawasaki ATV?
Models equipped with a Drive Belt Check system may alert you to check your belt by illuminating a light on the instrument cluster. Machines equipped with the Drive Belt Failure Detection System are put into a slowmode when the system is tripped.
What should I use to check my belt deflection?
Brake cleaner to clean out all the belt dust and trash and moly grease for the little bushings and the O rings on the secondary shafts. Oh and a torque wrench so you don’t drive the primary back in to far.
The belt deflection can be measured by placing a straight edge “ruler” ontop of the belt from the secondary to the primary. Using approx. 13 lbs of pressure with your finger, push down on the belt in the center between the primary and secondary.
Where is the belt light reset button on a Kawasaki P650?
Belt light reset procedure for late 2003 and later P650, P360, and BF650SRA. 1. Turn the ignition switch OFF. 2. Disconnect both sets of 5 pin connectors located above the CVT cover. Note: These connectors are located just beneath the shift handle on the right side of the 650; one is black and one is grey.
Where is the belt failure switch on a Kawasaki ATV?
1. Turn the ignition switch OFF. 2. Disconnect the belt failure switch at the 2-pin connector above the CVT cover. (Note: Just follow the wires coming from the rectangular black box on the CVT Cover to locate this connector.) 3. Disconnect both sets of 5 pin connectors located above the CVT cover.
Is the Kawasaki 360 belt light the same as the 2003 650?
The 360 belt light behavior is very similar to the 2003 650. If at first you can not find the right connectors, keep looking deeper because they really are there in a similar location to the P650. This has been the case with many 360 owners, they found them after looking further.