How much is an O2 sensor for Mercedes Benz?
The average cost for a Mercedes-Benz C300 oxygen sensor replacement is between $497 and $540. Labor costs are estimated between $161 and $203 while parts are priced at $336.
What kind of parts do I need for my Mercedes C230?
The market offers wide array of parts for your Mercedes Benz C230. These parts differ in types, kinds and classifications. You may find C230 auto parts, body parts, car parts or replacement parts. The market also offers durable C230 aftermarket parts, performance replacement parts, OEM parts, factory parts or used parts.
When did the Mercedes Benz C230 come out?
In 1993, its mark to the market as a competitive manufacturer of quality cars has been again imprinted with the introduction of a compact unit also labeled as the Baby Benz. A combination of a sports car and a luxury sedan—that was what the Mercedes Benz C230 was all about.
Where is the crankshaft position sensor located on a Mercedes Benz?
If the crankshaft position sensor is not operating properly, your car will run very erratically or perhaps not at all. Replacement of the sensor is not as easy as the camshaft sensor, unfortunately. The crankshaft sensor is located on the rear of the engine up against the firewall on the bell housing.
What happens if you change the ABS sensor on a Mercedes?
This repair guide will help you change the Mercedes wheel ABS speed sensor on models such as E, C, S, SL, CLS, ML, R, GL models. If the wheel speed sensor fails on your Mercedes-Benz, you will get an ABS warning light on the dashboard, plus your vehicle will go into LIMP mode, and the transmission may no longer shift properly.
How much does it cost to replace oxygen sensor in Mercedes Benz?
Here we will show you the steps you need to follow to replace an oxygen sensor successfully. New Oxygen 2 Sensor, which you can purchase online and save a lot. If you go to Amazon, you will see that new oxygen sensors prices for Mercedes-Benz cars range between $30 to $80.
Where is the OBD II port on a Mercedes Benz?
Your OBD II port where you plug in the scanner is located under the dash, usually right under the steering wheel. You can see an example in the picture below. Step 2: Locate the defective oxygen sensor.
How can I get fault code for Mercedes Benz?
Step 1: Get the fault codes. Scan your car’s ECU using an OBD 2 scanner. If you have not used an OBD II scanners before it is very easy. You will need an OBD scanner to get the fault codes. Here are the bestseller OBD 2 scanners on Amazon and any of these will work fine.