How much does it cost to replace a WRX clutch?
The average Subaru clutch replacement cost will range from $500 to $1,000 or more. Expect a Subaru Impreza clutch replacement cost between $1,200 and $1,400, with a similar range for a Subaru Forester clutch replacement cost and the Subaru WRX clutch replacement cost.
Why is my Subaru transmission making a high pitched noise?
In some cases, when bearing pre-load is near the limit of specification, this thermally induced pre-load change may cause damage to the bearings and result in a high-pitched noise from the transmission.
What kind of transmission does a Subaru Impreza have?
The following Subaru models equipped with the 5MT manual transmission may exhibit this condition: 2000-‘09 Legacy and Outback; 1999-2014 Forester; and 1999-2014 Impreza (Including WRX). Subaru offers an updated extension case featuring the addition of a “dish plate.”
What should I do if my Subaru transmission is bad?
In very severe cases, where metal contamination damage is extensive, a complete transmission replacement may be required. When reinstalling the transfer driven shaft, put a small amount of bearing grease on both roller bearings, then rotate the shaft in the outer races to distribute it evenly.
What causes a Subaru transmission case to shrink?
In cold temperatures, thermal contraction causes a shrinking of the transmission case. In high temperatures, thermal expansion causes the case to expand. These temperature changes affect the amount of pre-load on the transfer driven shaft bearings.
How to replace clutch and flywheel on Subaru by?
(Playback ID: mBf-9-32zV8grn8Q) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
How long does it take to replace a Subaru clutch?
This pictoral DIY covers complete dissassembly and reassembly over the entire job (no “repeat steps in reverse” finish). Dissasembly is covered from Steps 1 to 27. Reassembly is covered from Steps 28 to 52. This task could take from 12 to 20 hours, depending on how particular you are with cleaning all your parts.
Do you need a helper for a clutch replacement?
A helper is needed to work the floor jack to lower and raise the transmission while you steady it under the car. It is helpfull to use the Electrical & Torque Checklists below during reassembly. Check each item off the list as it is completed. LETS GET STARTED.