How much does it cost to replace a starter on a 2006 Jeep Commander?

How much does it cost to replace a starter on a 2006 Jeep Commander?

The average cost for a Jeep Commander starter replacement is between $293 and $320. Labor costs are estimated between $106 and $133 while parts are priced at $187.

How hard is it to put a starter on a Jeep?

Replacing the starter in your Jeep Wrangler is not a difficult task. And the task should not take long, as the starter is held on by just two bolts and two wires. The whole job will consist of working underneath the vehicle so that you have easier access to the starter.

Where is the starter located on a 07 Jeep Commander?

To access the starter you must remove the shield below the engine. The starter is a 4 to 5 inch diameter cylindrical assembly oriented longways, fore and aft. It will have 3 wires attached. 1 of the three is the battery cable [large diameter] It is attached at the junction of engine and transmission.

What should I do if my car starter is jammed?

First, turn your headlights on and start the car. If you hear a sound like your car’s trying to start but the headlights dim, your starter pinion is probably jammed. Open the car and use a wrench to twist the pinion, which will look like a small square stub sticking out of the motor.

What happens when the a / C goes on on a Jeep Commander?

The rear assist lights come on, the auto high beam/low beam changes on the computer, the air bag light comes on & chimes. If the A/C is on, it goes from face to feet & back up.

How can I tell if my car starter is bad?

Visually inspect the battery terminals. Pop the hood of your car and check the positive and negative terminals of the battery. If there is any dirt or corrosion, it can cause a bad connection and a lack of power to the starter.

Where is the starter located on a car?

The starter is a large electrical motor in a cylindrical housing, and it’s usually bolted to one side of the engine block. If you see a small, square stub (the pinion stub) sticking out of the end of the cylinder, turn it with your wrench until it moves freely in place.