How much does it cost to repair Nissan p0011 engine code?
The cost to diagnose the P0011 NISSAN code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
What does the OBDII code for Nissan Altima mean?
P0011 is a generic OBDII code. This means that it has the same definition for the Nissan Altima as it does on any other vehicle. VVT changes the frequency and distribution of gases entering and exiting the combustion chamber. It allows the engine to act as though it has different camshaft profiles…
What are the symptoms of Nissan Altima p0011?
Here are some of the typical symptoms of P0011 in the Nissan Altima: Poor Idle Quality – If the camshaft actuator fails while giving the engine aggressive valve timing, it’ll idle roughly.
What causes a car to throw a p0011?
There are quite a few different things that can cause the P0011. Here are the most common causes: Engine Timing – If the camshaft (s) are no longer synced to the crank properly (such as if the timing chain jumped a tooth), it can cause the engine timing to be off enough to throw the P0011 even though it’s not the Actuator’s fault.
What does engine code p0011 mean?
A P0011 code refers to the VVT (variable valve timing) or VCT (variable camshaft timing) components and the car’s PCM (powertrain control module) or ECM (engine control module). VVT is a technology used in the engine to allow it to get greater power or efficiency at different running points.
What does diagnostic trouble code p0011 mean?
P0011 is a diagnostic trouble code (DTC) for “Camshaft Position A – Timing Over-Advanced or System Performance (Bank 1)”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
What is a code po420 on Nissan Altima?
The P0420 code in a Nissan Altima will often be thrown one of your oxygen sensors are not functioning properly. Typically, the code will be triggered by the upstream oxygen sensor (before the converter). There aren’t usually any drivability issues associated with P0420.
What is this code p0011?
- or valve issues of the camshaft oil control valve for the bank 1 intake camshaft.
- Check the engine for it to be full of clean engine oil with the correct viscosity.
- The technician will scan and document the codes received and view the freeze frame data to see when the code was set.