How much brake fluid do I need for a change?
50ml of brake fluid is enough to perform a bleed on one set of cycle brakes (front and rear). If the old brake fluid is particularly dirty or discoloured we recommend completely flushing out the old fluid and replacing with new. In which case you may need additional fluid.
How do you change the brake fluid on a Toyota 4runner?
Ask a helper to pump the brake pedal a few times, then keep it pressed. Loosen the drain bolt using your wrench and watch for the bubbles. Repeat the pumping and loosening again and again. As soon as you start seeing fresh, clean fluid and no bubbles, tighten the bolt.
How much brake fluid do I need for a bleed?
Head down to the auto parts store or dealer’s parts department to pick up the correct fluid before you start working on the brakes. Good-quality brake fluid isn’t expensive; you’ll probably need two or three 12-ounce cans to bleed the system.
How long does Toyota brake fluid last?
As a rule, Toyota recommends that you change the brake fluid every two years or 20,000 miles, although several factors can affect the interval. No two drivers are the same, and some are harder on their brakes than others. It can also depend on the age of your car, how much you drive, and where you mostly drive.
What kind of brake fluid does a Toyota 4Runner use?
Brake fluid sold in North America is classified by the U.S. Department of Transportation (DOT) under their own rating system. Toyota 4Runners come with DOT 3 fluid. You can use DOT 4 fluid as well. DO NOT use DOT 5 fluid as it is not rated for use in ABS vehicles.
How much does it cost to change brake fluid in a Toyota?
I drove the car to the local Toyota dealer and requested they flush the system and reset the lights. After two days, the job was completed and the bill was $535!! They did have to use scan tools and two techs to do the system flush, but at this price I have to believe that Toyota does not have brake fluid replacement in the schedule.
Do you need a universal bleeder for a Toyota 4Runner?
For the 3rd (1996-2002) and 4th (2003-2009) generation Toyota 4Runners, you will need Motive Products Round Universal Bleeder #0101 . This item comes with the Round Universal Adapter #1101, which will fit various vehicles with brake fluid reservoirs that use a round cap smaller than 3.0 inches across.
What happens when you pump the brake fluid?
Pumping the brakes did not push fluid through the system and the brake, ABSand check VSC lights came on the dash. No air got in the system and the fluid reservoir was not low. The brake pedal feel was normal. I drove the car to the local Toyota dealer and requested they flush the system and reset the lights.