How do you set kickdown on Ford FMX?
Slide the kickdown cable end stop onto the inner wire. Move the throttle to wide open and hold it there while pulling the kickdown inner wire as tight as possible. Slide the cable end stop up against the kickdown throttle body fitting and tighten the set screw using the supplied 5/64″ Allen wrench. Release the throttle.
How do you install kickdown on Ford AOD?
Step 1: Remove any and all existing throttle valve (T.V.) linkage parts. Step 2: Remove the cable end stop, kickdown throttle body fitting, and T.V. cable adjuster from the engine end of the new Lokar T.V. cable. Leave the kickdown mounting bracket on the T.V. cable adjuster.
What do I need to install kickdown cable?
Install 10-24 Machine Screw & Locknut provided. (see Figure 2B) Bolt on inside of O.E. throttle lever. V-Notch in Throttle Adapter Bracket will interlock into throttle lever & O.E. Cable Stud & Nut is all that is needed to install. Screw & Nut not required.
How to install kickdown cable on a carburetor?
Step 1. Bolt Modified Throttle Lever Adapter to carburetor with original Accelerator Cable Stud & Nut (see Figure 2A) Step 2. Rotate to align Heartshape hole with hole in throttle lever. Install 10-24 Machine Screw & Locknut provided. (see Figure 2B) Bolt on inside of O.E. throttle lever.
How do you remove a kickdown cable adjuster?
Leave the kickdown mounting bracket on the kickdown cable adjuster. Remove the inner wire from the cable housing, and remove the transmission cable end assembly from the inner wire. Step 2:Remove the lower left tail housing bolt from the transmission.
Install 10-24 Machine Screw & Locknut provided. (see Figure 2B) Bolt on inside of O.E. throttle lever. V-Notch in Throttle Adapter Bracket will interlock into throttle lever & O.E. Cable Stud & Nut is all that is needed to install. Screw & Nut not required.
Step 1. Bolt Modified Throttle Lever Adapter to carburetor with original Accelerator Cable Stud & Nut (see Figure 2A) Step 2. Rotate to align Heartshape hole with hole in throttle lever. Install 10-24 Machine Screw & Locknut provided. (see Figure 2B) Bolt on inside of O.E. throttle lever.
Slide the kickdown cable end stop onto the inner wire. Move the throttle to wide open and hold it there while pulling the kickdown inner wire as tight as possible. Slide the cable end stop up against the kickdown throttle body fitting and tighten the set screw using the supplied 5/64″ Allen wrench. Release the throttle.