How do you reset the check engine light on a 1998 Toyota Camry?
Put the key into the ignition and turn on the car but don’t turn over the engine. Wait a few minutes then put the fuse back in place. You should notice the check engine light blinking a few times on the instrument panel, then it will go off.
How do you reset the check engine light on a Toyota Camry?
Push and hold the reset button on the trip meter. Turn the key back on again, but not to the start position. The odometer will display dashes that disappear one at a time, and then a set of zeros will appear. Keep holding the button down until the zeros go away and the odometer reading comes back.
How do you reset the check engine light on a 1999 Toyota Camry?
Turn the ignition key to the second position in the ignition, but don’t crank the engine (it won’t start anyway with the ECU fuse removed). Wait at least 3 minutes before putting the fuse back into the fuse panel. The check engine light will blink and then shut off.
How to reset check engine light in Toyota Camry?
Figure 1. Locate the fuse box near the steering column on the driver’s side. Check the diagram on the inside of the fuse cover to locate the ECU fuse. Pull the fuse labeled for the ECU. Figure 2. Pull the fuse designated for the ECU. Turn the ignition to the ON position only, but don’t turn over the engine. Wait for a few minutes.
How do you reset the ABS sensor on a Toyota Camry?
Open the hood of your Toyota and loosen the retaining nut on the cable clamp running to the negative battery terminal using a socket wrench. Slide the cable clamp off the terminal. Wait three full seconds before sliding the clamp back over the negative battery terminal. Tighten the retaining nut using a socket wrench.
Is there a way to reset the Check Engine light?
Regardless, here’s the quick and easy way to reset the CEL that is currently plaguing your dash. This article applies to the Toyota Camry (1997-2001). If you see the check engine light but your car is otherwise acting normally, chances are the check engine light is reporting something relatively minor.
How do you reset the SRS light on a Toyota?
Take a paperclip and unfold it. Jump the wire by attaching one end of the paperclip to each of the two terminals. This will reset the SRS light. Put the yellow electrical connector back in place and close the panel cover.
https://www.youtube.com/watch?v=6Uo6qpkbc3A