How do you reset the belt light on a 2003 Kawasaki Prairie 650?
Early 2003 650 Belt light reset procedure.
- Turn the ignition switch OFF.
- Disconnect the belt failure switch at the 2-pin connector above the CVT cover.
- Disconnect both sets of 5 pin connectors located above the CVT cover.
- Connect these 5 pin connectors to their opposite pairs (grey to black and black to grey).
How to troubleshoot a V belt belt failure?
Carefully align the flat idler on the slack side of the drive as close as possible to the driver sheaves Check machine components and guards, motor mounts, motor pads, bushings brackets and framework for stability, adequate design strength, proper installation and proper maintenance.
How do I Reset my drive belt on a Kawasaki ATV?
The information contained in the guide explains how to reset your Drive Belt Check system and/or the Drive Belt Failure Detection System. Models equipped with a Drive Belt Check system may alert you to check your belt by illuminating a light on the instrument cluster.
How can I tell if my belt drive is bad?
Observing signs of unusual belt wear or damage will help troubleshoot possible drive problems. Mark or note a point on the belt, or on one of the belts in a multiple V-belt drive. Wearing gloves, work around the belt(s), checking for cracks, frayed spots, cuts, or unusual wear patterns. Beware of pinch points.
What should I know about belt drive preventive maintenance?
• Proper belt installation procedures . • Belt drive performance evaluations . • Belt product knowledge . • Belt storage and handling . • Troubleshooting . PREVENTIVE MAINTENANCE Belt drive should have adequate guard Carefully inspect all belts * Note- If belt looks bad, it probably is 3
Carefully align the flat idler on the slack side of the drive as close as possible to the driver sheaves Check machine components and guards, motor mounts, motor pads, bushings brackets and framework for stability, adequate design strength, proper installation and proper maintenance.
The information contained in the guide explains how to reset your Drive Belt Check system and/or the Drive Belt Failure Detection System. Models equipped with a Drive Belt Check system may alert you to check your belt by illuminating a light on the instrument cluster.
Where is the belt failure sensor on a Kawasaki Prairie?
Let your Prairie cool for at least 15 minutes. Follow the belt failure sensor’s wiring from the rectangular box above the CVT belt cover on the right side of the motor to your Prairie’s wiring harness. Unplug the wiring’s 2-pin connector from the harness. Unplug the gray and black wiring connectors, located above the CVT belt cover.
Do you need to reset the belt light on an ATV?
The belt warning system on your ATV must be PROPERLY reset and should not be disabled or tampered with. This manual will show you how to properly reset it. Don’t get stranded out in the middle of nowhere without the information you need to reset your belt light and get back on the trail.