How do you replace the ignition coil on a lawn mower?
Remove the old ignition coil (armature) mounting screws. Disconnect the stop switch wire from the flywheel brake and remove the coil. Attach a replacement coil using mounting screws. Push the coil (armature) away from the flywheel and tighten one screw. Turn the flywheel so the magnets are on the opposite side from the ignition coil (armature)
Where are the DIP switches on a Mighty Mule?
Every Mighty Mule entry transmitter comes with identical factory settings, but you can personalize your code by repositioning the dip switches inside the Mighty Mule entry transmitter. Please review your installation manual for additional programming information. Can anyone open my Mighty Mule gate operator without my entry transmitter?
What happens when there is no spark from the ignition coil?
1 Power. Two positions of the ignition switch provide power to the positive primary post of the ignition coil. 2 Signal. With no external signal to the coil negative primary post, voltage would travel through the ignition coil windings without inducing any secondary spark. 3 Flow. 4 Open Circuits. …
What happens when you replace the coil wire on an engine?
You can replace the secondary coil wire on an engine that uses one with an equal length of vacuum hose and the engine will start and run. The powerful spark will travel down the hollow hose to the distributor cap, but the engine will stall under any load because of the weakened spark.
Why does my mule cut off like its out of gas?
If it is a single cylinder model I would suspect the coil/magneto. If it is a v-twin then I would lean toward fuel tank vent being clogged, plugged fuel filter, failing fuel pump relay, failing fuel pump, or the igniter. But each will need to be tested to know for sure.
Why does my fuel pump stop working on my Mule?
It could well be a clogged tank vent. If it is not the fuel tank vent that is stopping or slowing the fuel, then blow back through the fuel line that is connected to the pump. Clear any rust or debris in the tank from the fuel intake tube. If the problem remains check the pump itself by bypassing the fuel pump relay.
Why does my ignition coil keep going out?
Here is why! The leading cause of premature failure of an ignition coil is due to a worn or bad spark plug ignition cable. A bad spark plug ignition cable will have a much higher than normal resistance. This high resistance causes a very high amount of voltage to be generated from your ignition coil’s secondary winding.
What happens if you don’t have a stator coil?
The stator coil generates the power for the spark plug and other accessories on small engines Without a stator there would be no spark at all, meaning the engine won’t run. While a stator is dying, it can produce a weak spark, causing the engine to miss or run poorly. Symptoms are often worsened as the engine warms up.