How do you replace fuel line on Dyna Glide?
Many owners opt to replace the fuel lines while the fuel pump assembly is removed from the tank. The fuel lines tend to become brittle with age and are prone to leaking. Depress the release tab to remove the fuel filter retaining clip. Separate the fuel pump body from the end cap and remove the filter element along with the O-ring.
How do you change a fuel filter on a Harley Davidson?
If you are changing the fuel filter with the tank mounted on the bike, proceed with removing the console and gauges. Remove the fastening screws securing the console to the fuel tank. Depending on the model, removal of the seat may be required. With the console free from the tank, disconnect the gauge (s) and set the console assembly aside.
Where is the fuel tank on a Harley Davidson?
Remove your tank hardware in the front and rear of the tank. Don’t forget to unplug your bike’s fuel gauge before lifting on your tank. Have a safe spot ready for your fuel tank. Carefully lift up and back as you pull the fuel tank off of the motorcycle’s frame. Do not lift the tank into your bars, or controls.
How do you remove a fuel pump on a Harley?
Harley fuel pump and filter removal is a project you can do with ease. Bob LaRosa and Mark DiPietro take the time to cover all painted areas, drain fuel from the system and use the right tool to remove the pump and filter from the tank. JIMS Tools available at DennisKirk.com – See the JIMS Fuel Pump Retainer Remover Tool on DennisKirk.com.
How do you change a gas tank on a Harley Davidson?
Reach into the tank and push down on the fuel pump to remove it from the fuel pump housing so it will fit through the hole. Remove the complete fuel pump assembly including the fuel pump, fuel pump housing, fuel filter screen, hose, fuel level sender and float from the old fuel tank. 15.
How do you attach a fuel tank to a Dyna Glide?
Install the tank console and gauge cluster assembly. Connect all electrical harnesses before securing the console and tank trim to the fuel tank. Connect the fuel crossover line using a new length of fuel line if necessary. Re-connect the fuel gauge wiring harness. Attach the fuel supply line to the fuel tank.
Harley fuel pump and filter removal is a project you can do with ease. Bob LaRosa and Mark DiPietro take the time to cover all painted areas, drain fuel from the system and use the right tool to remove the pump and filter from the tank. JIMS Tools available at DennisKirk.com – See the JIMS Fuel Pump Retainer Remover Tool on DennisKirk.com.
How do you remove the fuel tank console?
After draining the fuel, remove the tank console and gauge cluster assembly. Remove the tank trim screws (if applicable) before removing the console screws. Lift the console assembly upwards to reveal the gauge cluster wiring harness connections and disconnect, as well as the fuel pump module connector. Set the console and gauges aside. Figure 7.