How do you remove cylinder from Honda ignition?
The shear-head bolts holding the cylinder in place can’t simply be removed with a wrench or screwdriver, since they are covered. You must first use a center-punch tool to make a small indentation in the cover, then use a drill with a 3/16-inch bit to drill a hole into the center of each bolt.
How do you disable a Honda ignition switch?
You must disable the electrical system by disconnecting the negative battery cable. This is done by loosening the black cable’s clamp and removing it from the terminal. Wait at least three minutes after removing the cable to ensure that all power is shut off from the electrical systems.
What happens if you remove the ignition switch?
The ignition switch’s connector should already be unplugged if you removed the switch; you also must disconnect the connectors to the immobilizer control unit and the lock cylinder/key light, which are both near the switch and cylinder.
Do you need a new Honda Civic ignition lock cylinder?
As much as you drive your Honda Civic around town, the moment you lose your keys is the moment you need to order a new Honda Civic ignition lock cylinder from AutoZone. Once it arrives, install it and use the new key to regain the ability to access and drive your vehicle.
How do you unlock an ignition lock cylinder?
First, insert the key and unlock the steering wheel. Next, use a flat blade screwdriver to press a small metal push pin that is located underneath the ignition lock cylinder. By depressing this switch, you’ll be able to unlock the cylinder from the housing.
Where is the cover on the ignition switch?
On most vehicles, there is a plastic or metal cover on the ignition lock cylinder. Remove the small screw that holds this cover on, typically located on the bottom of the switch. Once the screw has been removed, carefully slide the cover off the ignition lock cylinder.
What causes a fault in an ignition lock cylinder?
Most of the time, when a problem occurs within the ignition system, it will be caused by a fault within the ignition lock cylinder. Inside the lock cylinder are a series of tumblers where the key is inserted.
What’s the best way to remove ignition switch on a motorcycle?
Park your motorcycle on a flat, level surface with ample lighting nearby. Ideally, set up outdoors if the weather is clear or indoors with a lot of windows or bright lights. Be sure to have your tools close by. Before going any further with removing the ignition switch, you’ll need to disconnect your battery.