How do you drain fuel tank on Ava Voyager XII?
So, one of the most important things you should do is drain the carbs. Start by turning off the fuel tank petcock (if you have one, Voyager XII’s do not). Then, located in the float bowl of each carb is a small Phillips screw or bolt, these are usually angled to the side.
Are there any Tech Tips for the Ava Voyager?
The Tech Center does not contain all available tech tips for the Voyagers, the most recent are contained in the hardcopy newsletters, with still others contained in the Tech Tips Manual. A combination of all three will yield the greatest array of Tech Tips available. Not a member?
Where are Phillips screws on Ava Voyager XII?
Start by turning off the fuel tank petcock (if you have one, Voyager XII’s do not). Then, located in the float bowl of each carb is a small Phillips screw or bolt, these are usually angled to the side. Have a pan ready for any gas that will drain when you loosen these screws or bolts.
So, one of the most important things you should do is drain the carbs. Start by turning off the fuel tank petcock (if you have one, Voyager XII’s do not). Then, located in the float bowl of each carb is a small Phillips screw or bolt, these are usually angled to the side.
How to replace the fuel pump on a 1996 Dodge Caravan?
This video provides helpful step- by- step tips in replacing the fuel pump on a 1996-2002 Dodge Caravan, Plymouth Voyager or Chrysler Town and Country. The occasional loss of power at highway speeds prompted the recent replacement of the fuel filter and pump on a 2000 Caravan. So far results look promising. Loading…
What kind of air filter do I need for my Voyager?
A STP SA3915 replacement air filter will fit perfectly into the Voyager OEM white plastic basket by trimming approximately 1/8″ off two opposite ends with a razor cutter. Apply silicon or other sealant in the bottom of the basket and place the wire side of the new filter down into the sealant.
What kind of lubricant do you use on Kawasaki Ava Voyager?
Do not use gasoline, motor oil, or any other petroleum distillate, as this will cause deterioration of the rubber parts. When lubricating these shafts, Kawasaki recommends using a Poly Butyl Cuprysil grease (PBC is a special high temperature, water resistant grease).
A STP SA3915 replacement air filter will fit perfectly into the Voyager OEM white plastic basket by trimming approximately 1/8″ off two opposite ends with a razor cutter. Apply silicon or other sealant in the bottom of the basket and place the wire side of the new filter down into the sealant.
What kind of oil do I put in my Ava Voyager?
Recommended oil is 10w fork oil. There are two ways to go about changing the oil. The easy way is to drain out the old oil from the plug at the bottom of the fork. Remove the wheel and pump the lower fork tube up and down until no more oil comes out. When changing the oil, the shop manual says replace it with 330mL of new oil.
What should the tire pressure be on a Voyager?
B. Heavier loads-dual riding and/or luggage (from 200 lb. total up to maximum motorcycle capacity stated in the owner’s manual)-pressure of 36 psi front and 40 psi rear must be maintained. Please Note: For any dual riding or fully loaded use, 40 psi must be maintained in all Dunlop rear tires fitted to touring motorcycles.