How do you change the timing on a Harley Davidson?
Loosen the the timing plate screws with a slotted screwdriver, and turn the timing plate to adjust the timing. Recheck the timing marks with the timing light. Tighten the timing plate screws, and install the cover. Shut off the engine, and remove the timing light.
When do you need to replace the timing cover?
If any of those areas leak, the timing cover will have to be removed. Most often the failure will be in the gaskets or seals on the timing cover, but occasionally, there may be a crack or chip that will necessitate replacement of the timing cover itself. Step 1: Jack up the car. Make sure the car is in park, or in first gear if it is a manual.
How do you install an IP timing gear?
Apply sealant to the timing cover and install over the IP timing gear. Thread the 4 bolts in very loosely to make installation of the IP easier. Align the slot in the IP to mate with the dowel in the 4 o’clock position. Install the IP to engage with the IP timing gear about half way.
Where is the Y mark on the IP timing gear?
Take your jiffy marker and draw a line on the IP timing gear from the tooth with the Y mark on it to the 53rd tooth which is directly across the gear. I went clockwise with tooth 1 being the one after the Y mark. Now carefully place the IP gear so it engages with the cam gear. The jiffy marker line should be straight up and down.
Is the belt too tight on a Dyna FXD?
I think the Harley specs run the belt too tight. my 2001 dyna FXD has 131k on the original belt and I have done my own maintenance including belt tension since warranty expired at 10k in 2001. If the belt chirps it is too loose.
If any of those areas leak, the timing cover will have to be removed. Most often the failure will be in the gaskets or seals on the timing cover, but occasionally, there may be a crack or chip that will necessitate replacement of the timing cover itself. Step 1: Jack up the car. Make sure the car is in park, or in first gear if it is a manual.
Where is the thread timing mark on a Harley Davidson?
Thread TIMING MARK VIEW PLUG (Part No. HD 96295-65D) into timing inspection hole. Be sure view plug does not touch flywheel. 1a. See Figure 1. Locate the proper timing marks for your engine.
How do you change ignition timing on a Harley Davidson?
1. See Figure 4. Remove outer cover pop rivets (1), outer timer cover (2), inner cover screws (3), inner cover (4) and gasket (5). 2. Loosen timer plate studs (6) just enough to allow sensor assembly (8) to be rotated using a screwdriver in the plate’s notch. 3.