How do you change spark plugs on 1997 maxima?
Spark plugs on a 1997 Maxima can easily be replaced in an hour or two using a few simple tools. Unhook the ground cable from the negative battery post by loosening the retaining bolt with a socket then pulling the clamp off the post. Check the gap on the new spark plugs using a feeler gauge. It should measure 0.043 inch. Adjust if necessary.
How do you replace a spark plug on a car?
Install the new spark plug into the head using a spark plug socket and extension. Insert the coil onto the new spark plug. Reinstall the two screws that secure it using a Phillips head screwdriver. Press the electrical connector onto the coil by hand. Repeat this process to replace the other spark plugs on the engine.
How do you install a new Phillips head spark plug?
Apply a thin coat of anti-seize compound to the threads on the new spark plug. Install the new spark plug into the head using a spark plug socket and extension. Insert the coil onto the new spark plug. Reinstall the two screws that secure it using a Phillips head screwdriver. Press the electrical connector onto the coil by hand.
Where are the spark plugs on a Nissan Maxima?
The spark plugs on a 1997 Nissan Maxima are located in the cylinder head and ignite the mixture of air and gas in the combustion chamber. Periodically, the spark plugs must be replaced; failure to do so will lower the efficiency of your engine and create environmentally-harmful emissions.
Install the new spark plug into the head using a spark plug socket and extension. Insert the coil onto the new spark plug. Reinstall the two screws that secure it using a Phillips head screwdriver. Press the electrical connector onto the coil by hand. Repeat this process to replace the other spark plugs on the engine.
Apply a thin coat of anti-seize compound to the threads on the new spark plug. Install the new spark plug into the head using a spark plug socket and extension. Insert the coil onto the new spark plug. Reinstall the two screws that secure it using a Phillips head screwdriver. Press the electrical connector onto the coil by hand.