How do you change a transmission cooler line?
Step by Step Guide to Replace the Cooler Lines
- Raise the Vehicle. It would be best to work on level ground to ensure that your vehicle does not lean too much on the jack when lifted.
- Drain the Transmission Fluid.
- Remove the Old Line.
- Install the New Cooler Line.
- Replenish the Transmission Fluid.
- Double-check.
Is it easy to replace transmission cooler lines?
Like all parts of an engine, transmission cooling lines can wear out. If they break or develop a leak, you will lose transmission fluid, leaving your car vulnerable. Thankfully this is a fairly simple fix, and most transmission line repairs cost between $100 and $500 dollars.
How do you remove a transmission cooler fitting?
To use the wrench, slide the open end of the wrench over the cooler line, then slide the wrench down the line until it reaches the nut used to secure the line to the transmission. Use the wrench to loosen the nut located at the end of each line, then pull the line away from the transmission to remove it.
Where is the transmission cooler line located?
Metal transmission cooler lines are typically pre-bent with fittings that are held on by a flare at each end of the line. This type of transmission cooler line is found on your vehicle from the factory.
How do you use the transmission cooler line disconnect tool?
Use 1/2″ size for Ford Super Duty Trucks, F250, F350 and F450. Tip is specially stepped to fit connector. Simply push the line toward the connector, then engage tool and pull line from connector. Set comes skin packed with a bead chain.
How do you replace transmission cooler lines in a car?
Attach the new cooler lines to the radiator and the transmission as well as any hangers that they may have been suspended from. Fill the transmission with the manufacturer’s recommended fluid to the proper level indicated in Owner’s Manual. Start the vehicle and check the transmission dipstick to make sure the fluid is at the proper level.
How much does it cost to install a transmission cooler?
While installing basic rubber lines might work for most, in some cases, your vehicle may need custom lines, which are more costly than standard transmission lines. Depending on the cooler you purchase and your lines, you can spend as little as $20 extra to install a cooler, or in some cases, as much as $150 or more.
How does a transmission cooler work in a radiator?
In most applications where the external trans cooler is used in addition to the factory one, you will need to route the new transmission lines from the radiator to the external cooler. The below transmission cooler installation diagram shows the transmission fluid flow direction and how the fluid will be routed through a new external cooler.
What to do if your transmission cooler is leaking?
Help! Transmission Cooler line leaking? – YouTube Help! Transmission Cooler line leaking? If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.