How do I turn on structure scanning?
To turn on/off Flip Left/Right, highlight Flip Left/Right on the Structure Options menu and press EntEr.
What is the difference between LSS 1 and LSS2?
There will be a slight increase in range and a sharpening of the images due to the HD quality of the LSS-2. Most users have reported that the LSS1 Downscan is better quality than the LSS2. The LSS1 is shorter and more mounting friendly.
How far should a transducer be in the water?
Ensure the boat is in water greater than 2′ but less than the depth capability of the unit and the transducer is fully submerged. Remember the sonar signal cannot pass through air. If the unit is working properly gradually increase the boat speed to test high-speed performance.
Which way should a transducer point?
So the short answer is that no, it doesn’t matter which way you face the “front” of your transducer.. the read out is going to look just the same to you. You do, however, want the BOTTOM of your transducer to face as straight down as you can, within reason.
Can a transducer shoot through fiberglass?
The standard (83/200 kHz) pod style transducer and standard (83/200 kHz) skimmer transducer, have a proven track record of performing well shooting through a fiberglass hull when installed correctly. You will lose 10-15% of sonar performance when shooting through fiberglass.
What is the Lowrance HDS Gen2 touch installation manual?
About this manual This manual is a reference guide for installing the Lowrance HDS-7, HDS-9, and HDS-12 Gen2 Touch system. The manual does not cover basic background information about how equipment such as radars, echo sounders and AIS work.
Where to mount a Lowrance Micore lss-1?
The LSS-1 can be mounted under the dash, in the rod locker or in the battery compartment. Select a mounting location that will protect the LSS-1 from standing water. To mount the LSS-1: 1.
How to install lss-1 on a boat?
Choose a transducer location and then route the transducer cable to the location where the LSS-1 will be installed. 2. Place the transducer bracket against the transom and then align the bottom of the transducer with the bottom of boat. Use a pencil to mark the pilot holes through the slots in the transducer bracket. 3.
What kind of cable do I need to mount a lss-1?
To mount the LSS-1: 1. Make sure the transducer cable is long enough to connect to the LSS-1 from the desired transducer mounting location. If the 20’ transducer cable is not long enough, a 10’ extension cable is available (part number: 99-006). 2.