How do I reset my Cisco 2950 password?
Step-by-Step Procedure
- Attach a terminal or PC with terminal emulation (for example, Hyper Terminal) to the console port of the switch.
- Unplug the power cable.
- Power the switch and bring it to the switch: prompt:
- Issue the flash_init command.
- Issue the load_helper command.
- Issue the dir flash: command.
How do I reset my Cisco Catalyst 2960 password?
To reset your Cisco 2960 password, connect your console cable to the switch and open up your terminal emulator software, you can use minicom if you are using Linux. Power on the switch while holding the mode button. Release the mode button after you see the screen below in your terminal emulator software.
What is cisco default password?
admin
Most routers and switches by Cisco have default passwords of admin or cisco, and default IP addresses of 192.168. 1.1 or 192.168. 1.254. However, some differ as shown in the table below.
What is my cisco username and password?
When you access the device, you should be asked to enter a username and password. The default user name of your Cisco router is either “admin” or “cisco”. The default password of all Cisco routers is either “admin”, “cisco” or is a blank field.
What is the default password for Cisco switch?
Is there a password recovery button on catalyst 2955?
Note: LED position may vary slightly depending on the model. The Catalyst 2955 series switches do not use an external mode button for password recovery. Instead the switch boot loader uses the break-key detection to stop the automatic boot sequence for the password recovery purposes.
Is there a default password for the switch 2950?
there is no default username and password on a 2950 it would have been specifically configured on the 2950 by someone. Some devices like the 2800 series do come with a username and paswword on it, haven’t figured out the point of that right out of the box and its cisco/cisco.
How to power a Cisco switch 2960 or 3560?
Power the switch and bring it to the switch: prompt: For 2900XL, 3500XL, 2940, 2950, 2960, 2970, 3550, 3560, and 3750 series switches, do this: Hold down the mode button located on the left side of the front panel, while you reconnect the power cable to the switch.