How do I install a new throttle cable?
- Step 1: Locate the throttle cable.
- Step 1: Disconnect the throttle cable at the throttle body.
- Step 2: Disconnect the throttle cable from the retaining bracket.
- Step 3: Pull the throttle cable through the firewall.
- Step 4: Disconnecting the throttle cable from the accelerator pedal.
How do you adjust the throttle cable on a CRF?
When adjusting the cable take the slack out of the pull side then slowly adjust the return as it will delay the throttle from snapping back. If it starts to tighten up back off the return a little bit. Be sure to always maintain the throttle grip freeplay of 1/8-1/4″.
Where can I buy 4 stroke throttle cable?
New videos every month! Your leader for off-road parts, apparel and accessories for dirt bikes, ATV’s, Side X Side’s, and street motorcycles. https://www.rockymountainatvmc.com/ Shop Our 4 Stroke Throttle Cables!
What should I do if my throttle cable is hanging?
Move the handlebars extreme left and right and ensure throttle movement/return. If it still is hanging, then inspect the cable routing and pay particular attention to the cables where the gas tank sits. This is a common pinch point.
Why are the throttle cables at the CARB end?
The throttle was always sluggish and when I had it apart I noticed that the ends of the cables near the grip were slightly freyed. So I brought a new pair, installed them, kept the adjustments at the Carb end exactly the same, but its still very sluggish on the return and now the bike wont idle at all.
When adjusting the cable take the slack out of the pull side then slowly adjust the return as it will delay the throttle from snapping back. If it starts to tighten up back off the return a little bit. Be sure to always maintain the throttle grip freeplay of 1/8-1/4″.
New videos every month! Your leader for off-road parts, apparel and accessories for dirt bikes, ATV’s, Side X Side’s, and street motorcycles. https://www.rockymountainatvmc.com/ Shop Our 4 Stroke Throttle Cables!
The throttle was always sluggish and when I had it apart I noticed that the ends of the cables near the grip were slightly freyed. So I brought a new pair, installed them, kept the adjustments at the Carb end exactly the same, but its still very sluggish on the return and now the bike wont idle at all.
Move the handlebars extreme left and right and ensure throttle movement/return. If it still is hanging, then inspect the cable routing and pay particular attention to the cables where the gas tank sits. This is a common pinch point.