How do I adjust my windscreen wipers?
Adjusting the wiper blade alignment is even simpler and has fewer steps. You just need to grab your pliers and bend your wiper arms back into the right position. It is actually good to use two sets of pliers for this job. You can hold the wiper arm in place with one set and twist with another.
How do you change the windshield wiper on a Nissan?
Start on the driver’s side of your vehicle. Most blades are held in place with a tiny clip. Push that clip up towards the arm and push the blade backwards, as if you were sliding it down the wiper arm. Once the blade is free from the hook, push the blade a few inches down the arm to disconnect it.
What to do if your windshield wiper blade slips?
If the arm slips, you will need to replace it. Mark where the windshield wiper blade rests. If your wiper problem was not the result a loose nut, your wiper arm might be stripped out. In this case you need to replace it. The new arm needs to rest exactly where the original rested to insure proper travel.
How can I tighten the retaining nut on my windshield wiper?
Make sure that your wiper arm is in the correct resting position on the windshield (it should land on the same mark you made with the original wiper). Gently tap the arm down onto the shaft. It is ideal to use a tool that will not scratch your new wiper arm. Rubber mallets work well for this. Clean the threads for the retaining nut.
How to test the travel of a windshield wiper?
Test the travel of the arm for proper operation. Spray water or windshield wiper fluid onto your windshield. Next turn the ignition key on and then turn on the wipers. If the wiper arms clear each other, move smoothly and do not travel into the molding at the edge of the windshield, turn off the wiper switch and ignition key.
How do you install a new windshield wiper shaft?
Install the new arm. Line up the splines so that they mate with the shaft. Make sure that your wiper arm is in the correct resting position on the windshield (it should land on the same mark you made with the original wiper). Gently tap the arm down onto the shaft. It is ideal to use a tool that will not scratch your new wiper arm.
What should I do if my windshield wiper arm slips?
Test the wipers. Turn the ignition key on, turn the wipers on and test the travel of the arm for proper operation. If the arm slips, you will need to replace it. Mark where the windshield wiper blade rests. If your wiper problem was not the result a loose nut, your wiper arm might be stripped out. In this case you need to replace it.
How can I adjust the tension on my windshield wipers?
This procedure adjusts the tension in the wiper blades. Examine the park line, which looks like a small, horizontal mark on your windshield. Make certain your windshield wiper blade heel parked within 5 mm or almost 1/4 inch of the park line.
How do you remove a nut from a windshield wiper?
Verify that the arm position is still correct and use a small flat screwdriver to pry the plastic cap covering the nut at the base of the arm away from the recessed nut well. The plastic cap may have a small slot to assist in inserting the screwdriver. With this dust cap removed, you will have the access you need to remove the nut.